Fujitsu PRIMERGY TX100 S1 기술 매뉴얼 - 페이지 25

{카테고리_이름} Fujitsu PRIMERGY TX100 S1에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX100 S1 32 페이지. For tx100 s1
Fujitsu PRIMERGY TX100 S1에 대해서도 마찬가지입니다: 사양 (13 페이지), 서비스 보충 설명서 (46 페이지), 옵션 매뉴얼 (46 페이지)

페이지 인쇄

Replacing the lithium battery

In order to save the system information permanently, a lithium battery is

installed to provide the CMOS-memory with a current. When the charge is too

low or the battery is empty, a corresponding error message is provided. The

lithium battery must then be replaced.

The lithium battery must be replaced with an identical battery or a battery

type recommended by the manufacturer (CR2032).

Do not throw lithium batteries into the trash can. It must be disposed of

in accordance with local regulations concerning special waste.

Make sure that you insert the battery the right way round. The plus pole

must be on the top!

Figure 7: Replacing the lithium battery

Ê Press the locking spring into direction of the arrow (1), so that the lithium

battery jumps out of its socket.

Ê Remove the battery (2).

Ê Insert a new lithium battery of the same type into the socket (3) and (4).

D2679-B11 (TX100 S1)

Technical Manual