Fujitsu SK-91464A-100PMC 사용자 설명서 - 페이지 20

{카테고리_이름} Fujitsu SK-91464A-100PMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-91464A-100PMC 28 페이지. Mb91460 series

5 Connectors

The following figure shows the power connection jack X12. This connector is used to

connect an external unregulated DC power supply voltage (9V-12V DC) to the evaluation

board.

Connector X12:

It is recommended to use 9V DC input to minimize the power dissipation of the voltage

regulators.

All pins (except oscillator Pins) of the microcontroller are directly connected to X1 and X2 as

follows:

Connector

X1 (1 – 50)

X2 (51 – 100)

The odd pin numbers are located on the one side and the even pin numbers are located on

the other side of the connector.

Two 9-pin D-Sub female connectors are used

for the serial interface UART"A" and UART"B".

TXD is the transmit output, RXD is the receive input.

The DTR or RTS signal can be used to generate a reset.

Please use a 1:1 cable for PC-connection.

FMEMCU-UG-910025-15

SK-91464A-100PMC User Guide

Chapter 5 Connectors

Shield is connected to positive voltage supply

(+)

Center is connected to ground (GND)

MCU Pins

1 – 50

51 – 100

Connectors X3, X5:

- 20 -

GND DTR RxD TxD

CTS RTS DSR