Fujitsu SK-91465X-100PMC 사용자 설명서 - 페이지 18
{카테고리_이름} Fujitsu SK-91465X-100PMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-91465X-100PMC 40 페이지.
페이지 인쇄
Jumper
JP37
(LIN A enable)
JP32
(LIN A Master)
JP38
(VBAT_A)
Default: grey
Table 3-6: UART "B"/ LIN "A" jumper settings
3.6 UART "C" / LIN "B"
One RS232-transceiver (U10) or one LIN-transceiver (U8) can be connected to one of the
microcontroller's UART interfaces. Connect to D-Sub X12 corresponding RS232 or LIN
cable. By default RS232 is selected to X12.
JP67 Selects if RS232 or LIN is connected to SIN6 of MCU
JP68 Selects if RS232 or LIN is connected to SOT6 of MCU
JP65 Selects if UARTC or LINB is connected to pin2 of X12
JP69 Some programs (e.g. Terminals) need a connection between CTS and RTS
JP57 Enable LIN-Transceiver
JP54 Selects LIN Master mode
JP60 Connects Vs (Pin 1 of X12) to Vin
Jumper
JP67
(UART C / LIN B)
JP68
(UART C / LIN B)
JP65
(X12 pin2)
JP69
(RTS-CTS)
JP57
(LIN B enable)
JP54
(LIN B Master)
UG-910056-11
SK-91465X-100PMC User Guide
Chapter 3 Jumpers and Switches
Setting
Description
Closed
LIN-transceiver is enabled
Open
LIN-transceiver is disabled
Closed
LIN Master-mode
Open
LIN Slave-mode
Closed
Vs of LIN B is powered by the board
Open
No voltage supply to Vs of LIN B
Setting
Description
1-2
SIN6 of the MCU is connected to U10 (RS232)
2-3
SIN6 of the MCU is connected to U8 (LIN)
1-2
SOT6 of the MCU is connected to U10 (RS232)
2-3
SOT6 of the MCU is connected to U8 (LIN)
1-2
BUS Signal (LINB) is connected to pin2 of X12
2-3
Tx Signal (UARTC) is connected to pin2 of X12
Closed
RTS and CTS of X12 are connected
Open
RTS and CTS of X12 are not connected
Closed
LIN-transceiver is enabled
Open
LIN-transceiver is disabled
Closed
LIN Master-mode
Open
LIN Slave-mode
- 18 -
© Fujitsu Microelectronics Europe GmbH