Fujitsu SK-96320-80PMC 사용자 설명서 - 페이지 22

{카테고리_이름} Fujitsu SK-96320-80PMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-96320-80PMC 34 페이지.
Fujitsu SK-96320-80PMC에 대해서도 마찬가지입니다: 사용자 설명서 (34 페이지), 사용자 설명서 (34 페이지)

페이지 인쇄

4 Programming the internal Flash memory

All Flash devices have an internal bootloader for asynchronous- as well as synchronous-

Flash-programming:

< asynchronous-serial Flash-programming via X3

< synchronous-serial Flash-programming via X17

4.1 Asynchronous Mode

In order to program the Flash-ROM asynchronously, the tool "Fujitsu Flash MCU

Programmer for FMC16FX" can be used. This tool is available free on the Fujitsu Micros

DVD or Web Site (http://mcu.emea.fujitsu.com/: select < Software < Utilities)

The following procedure must be followed to enable Flash Programming:

1. Power off the board

2. Connect the Evaluation Board UART"A" or UART"B" to your serial PC communication

port. A straight 1:1 cable connection has to be used.

3. Check the Jumper-settings according to the UART as described in chapter 3.5

4. Configure the mode:

Dip-Switch S2

(Flash mode)

5. Power on the board

FMEMCU-UG-960010-12

SK-96320-80PMC User Guide

Chapter 4 Programming the internal Flash memory

MD0 MD1 MD2 nc

- 22 -

OFF