Fujitsu SK-96370-144PMC-GDC 사용자 설명서 - 페이지 30

{카테고리_이름} Fujitsu SK-96370-144PMC-GDC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-96370-144PMC-GDC 36 페이지. Mb96300 series

페이지 인쇄

5.1.3 Reset (optional)

Depending on the programming software a reset signal might be generated by RTS or DTR

line. In order to use this optional feature additional jumper have to be set:

Jumper

Programming

JP23

UART0

(DTR/RTS)

JP38

UART2

(DTR/RTS)

JP33

UART0 or

UART2

(RESET A/B)

JP41

UART0 or

UART2

(DTR / DTRx)

5.1.4 Flash Programming

1) Configure the microcontroller mode:

(Programming Mode)

2) Connect the configured UART (see above) to your serial PC communication port.

A straight 1:1 cable connection has to be used.

3) Start the tool "Fujitsu Flash MCU Programmer" software and make the settings:

Select Crystal

Open Source

(MHX-File)

Start

programming

FMEMCU-UG-960014-10

SK-96370-144PMC-GDC User Guide

Chapter 5 Programming the internal Flash memory

Setting Description

UART

1-2

2-3

1-2

2-3

1-2

2-3

1-2

2-3

Table 5-3: Jumper Settings for reset signal

DIP-Switch S1

Set Device Type

MB96F379R/Y

4 MHz

Application.MHX

DTR signal of X5 is used as reset source

RTS signal of X5 is used as reset source

DTR signal of X9 is used as reset source

RTS signal of X9 is used as reset source

LIN-UART 0 (X5) is used to generate reset

LIN-UART 2 (X9) is used to generate reset

No negation for the DTR/RTS signal

DTR/RTS signal is negated

MD0 MD1 MD2 nc

OFF

Select COM Port

- 30 -