Fujitsu SK-96390-100PMC 사용자 설명서 - 페이지 13
{카테고리_이름} Fujitsu SK-96390-100PMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-96390-100PMC 32 페이지. Mb96300 series
페이지 인쇄
2 Jumpers and Switches
This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting is shown with a grey shaded area.
2.1 Operating Mode (S2)
This switch controls the MCU operation mode after Reset.
Please take care of the following mode settings:
DIP switch
(Not used)
DIP-Switch S2
(RUN Mode)
Figure 2-1: MCU mode switch: RUN mode (Fixed Vector Mode)
DIP-Switch S2
(Programming Mode)
Figure 2-2: MCU mode switch: Flash Programming mode
© Fujitsu Microelectronics Europe GmbH
SK-96390-100PMC User Guide
Chapter 2 Jumpers and Switches
ON (closed)
S2-1
(MD0)
OFF (open)
S2-2
ON (closed)
(MD1)
OFF (open)
ON (closed)
S2-3
(MD2)
OFF (open)
ON (closed)
S2-4
OFF (open)
Table 2-1: MCU Operating Mode
MD0 MD1 MD2 nc
1
2
MD0 MD1 MD2 nc
1
2
Setting
Logical value
Not connected
ON
OFF
3
4
ON
OFF
3
4
- 13 -
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
UG-960017-11