Indesit AWD129NA 서비스 매뉴얼 - 페이지 13

{카테고리_이름} Indesit AWD129NA에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit AWD129NA 20 페이지.

Notices

n1040061: Trouble-shooting.

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Intervention procedure on 2000 washing machines

1. Reading the error code

The fault on the appliance is signalled via:

1. the continuous rotation of the selector knob

2. the action, for the first 4', of the electrovalve and the drain pump

3. the door becomes unlocked

4. the led flashes:

the number of flashes indicates the fault code; the code should be read as follows:

· each fast flash (2/3 flashes of the led very close together) represents one code value

· the fault code is evaluated by counting the number of flashes occurring at 3/4" intervals from one another

· stop counting when the washing machine waits the equivalent of approximately 8/9" between flashes

· the procedure is repeated by the appliance cyclically

E.g.: F03

(FIGURE NT 00)

2. Autotest

Should the washing machine not be signalling an error, you can check it using a serial key and using a particular autotest cycle,

which is to be activated as follows:

1. bring the washing machine to reset position (coloured ball) for at least 5" and wait until the led flashes on reset mode

2. insert the hardware key into the serial outlet

3. position the switch situated on the key in TEST position

4. wait for the door to lock and for the selector to start turning

5. position the switch situated on the key in PC position

the appliance will carry out the following cycle:

· selector moves on up to position 0 (12h if the appliance has a delay, programme 1 if it has no delay)

· loads the wash electrovalve for approx. 10"

· loads the pre-wash electrovalve for approx. 10"

· loads the wash electrovalve and pre-wash electrovalve at the same time until the pressure switch is on full

· heats up to 30° and moves the motor in both directions

· selector moves on for 9 notches

· drains and spins

· the selector knob stops on one of the reset positions

· STOP

mod.AWD129NA

page 13