Indesit bwe 71683x w eu 사용자 설명서 - 페이지 14
{카테고리_이름} Indesit bwe 71683x w eu에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit bwe 71683x w eu 18 페이지.
페이지 인쇄TROUBLESHOOTING
The washing machine may occasionally fail to work . Before contacting the Technical Assistance Service, make sure that the
problem cannot be easily solved using the following list .
Anomalies
The washing machine does
not start .
The wash cycle does not start .
The washing machine does
not fill with water ("H2O"
flashes on the display) .
The washing machine
continuously loads and
unloads water .
The washing machine does
not drain or spin .
The washing machine
vibrates a lot during the spin
cycle .
The washing machine leaks .
The "Options" and START/
indicator lights
PAUSE
flash rapidly and the display
visualises an error code (e .g .:
F-01, F- . . .) .
There is too much foam .
The Push & Wash function
does not activate .
14
Possible causes / Solution
The appliance is not plugged into the socket, or not sufficiently to make contact .
There is no power in the house .
The washing machine door is not closed properly .
The ON/OFF
button has not been pressed .
The START/PAUSE
button has not been pressed .
The water tap has not been opened .
A delay has been set for the start time .
The water inlet hose is not connected to the tap .
The hose is bent .
The water tap has not been opened .
There is no water supply in the house .
The pressure is too low .
The START/PAUSE
button has not been pressed .
The drain hose is not fitted between 65 and 100 cm from the floor .
The free end of the hose is immersed in water .
The wall drainage system does not have a breather pipe .
If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the
Technical Assistance Service . If the home is on one of the upper floors of a building, there may be problems
relating to back-siphonage, causing the washing machine to fill with water and drain continuously . Special
anti-siphon valves are available in shops and help to prevent this inconvenience .
The cycle does not include drainage: with certain cycles it must be started manually .
The drain hose is bent .
The drainage duct is clogged .
The drum was not unlocked correctly during installation .
The washing machine is not level .
The washing machine is tucked between furniture cabinets and the wall .
The water inlet hose is not screwed on properly .
The detergent dispenser drawer is obstructed .
The drain hose is not properly attached .
Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again .
If the problem persists, contact the Technical Assistance Service .
The detergent is not suitable for machine washing (it should be marked with "for washing machine use" or
"hand wash and machine wash" or similar) .
Too much detergent was used .
After switching on the machine, a control other than Push & Wash was activated . Switch the machine off and
press the Push & Wash button .
User manual