Indesit IWME 147 사용 설명서 지침 - 페이지 2

{카테고리_이름} Indesit IWME 147에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IWME 147 20 페이지.
Indesit IWME 147에 대해서도 마찬가지입니다: 사용 설명서 지침 (20 페이지)

페이지 인쇄

Installation

! Keep this instruction manual in a safe place for

future reference. Should the appliance be sold, tran-

sferred or moved, make sure the instruction manual

accompanies the washing machine to inform the

new owner as to its operation and features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has

been damaged during transport. If this is the

case, do not install it and contact your retailer.

will not interfere with the operation of the machine.

4. Seal the gaps using the plastic plugs provided.

5. Keep all the parts: you will need them again

if the washing machine needs to be moved to

another location.

! Packaging materials are not children's toys.

Levelling

Your machine may make a considerable

amount of noise if the two front feet have not

been adjusted correctly.

1. Install the washing machine on a flat sturdy

floor, without resting it up against walls, furniture

cabinets or other.

3. Remove the 4 pro-

tective screws and the

rubber bush with the

respective spacer, si-

tuated on the rear of the

appliance (see also the

installation leaflet).

NB:The plastic spacers

may fall down inside the

machine once the bolt

has been removed, and

2. If the floor is not

perfectly level, com-

pensate for any une-

venness by tightening

or loosening the adju-

stable front feet (see

figure); the angle of

inclination, measu-

red according to the

worktop, must not

exceed 2°.

Levelling your appliance correctly will provide it with

stability and avoid any vibrations, noise and shifting

during operation. If it is placed on a fitted or loose

carpet, adjust the feet in such a way as to allow

enough room for ventilation beneath the washing

machine.

Electric and water connections

Connecting the water inlet hose

3. Make sure there are no kinks or bends in

the hose.

! The water pressure at the tap must be within the

values indicated in the Technical details table

(on the next page).

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Ensure that the supply taps are allowing water

through. Old taps may seize in the closed

position and thus prevent water reaching the

machine.

1. Connect the supply

pipe by screwing it

to a cold water tab

using a ¾ gas threa-

ded connection (see

figure).

Before performing the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the other

end of the water inlet

hose to the washing

machine,

screwing it onto the

appliance's cold wa-

ter inlet, situated on

the top right-hand

side on the rear of the

appliance (see figure).