Indesit IWME 147 사용 설명서 지침 - 페이지 2

{카테고리_이름} Indesit IWME 147에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IWME 147 20 페이지.
Indesit IWME 147에 대해서도 마찬가지입니다: 사용 설명서 지침 (20 페이지)

페이지 인쇄

Installation

Keep this instruction manual in a safe place for future

reference. Should the appliance be sold, transferred or

moved, make sure the instruction manual accompanies

the washing machine to inform the new owner as to its

operation and features.

Read these instructions carefully: they contain vital infor-

mation on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has been dama-

ged during transport. If this is the case, do not install it

and contact your retailer.

of the machine.

4. Seal the gaps using the plastic plugs provided.

5. Keep all the parts: you will need them again if the wa-

shing machine needs to be moved to another location.

Packaging materials are not children's toys.

Levelling

Your machine may make a considerable amount of noise if the

two front feet have not been adjusted correctly.

1. Install the washing machine on a flat sturdy floor,

without resting it up against walls, furniture cabinets or

other.

3. Remove the 4 protective

screws and the rubber bush

with the respective spacer,

situated on the rear of the

appliance (see also the

installation leaflet).

NB:The plastic spacers

may fall down inside the

machine once the bolt has

been removed, and will not

interfere with the operation

2. If the floor is not per-

fectly level, compensate

for any unevenness by

tightening or loosening

the adjustable front feet

(see figure); the angle

of inclination, measured

according to the worktop,

must not exceed 2°.

Levelling your appliance correctly will provide it with sta-

bility and avoid any vibrations, noise and shifting during

operation. If it is placed on a fitted or loose carpet, adjust

the feet in such a way as to allow enough room for venti-

lation beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

3. Make sure there are no kinks or bends in the hose.

The water pressure at the tap must be within the values

indicated in the Technical details table

(on the page 5).

If the water inlet hose is not long enough, contact a

specialist store or an authorised serviceman.

Ensure that the supply taps are allowing water throu-

gh. Old taps may seize in the closed position and thus

prevent water reaching the machine.

1. Connect the supply

pipe by screwing it to a

cold water tap using a ¾

gas threaded connection

(see figure).

Before performing the

connection, allow the

water to run freely until it is

perfectly clear.

2. Connect the other end of

the water inlet hose to the

washing machine,

screwing it onto the ap-

pliance's cold water inlet,

situated on the top right-

hand side on the rear of the

appliance (see figure).