Indesit BAAN 40 FNF SWD 사용 설명서 - 페이지 8

{카테고리_이름} Indesit BAAN 40 FNF SWD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit BAAN 40 FNF SWD 12 페이지. Refrigerator/freezer combination

페이지 인쇄

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to disconnect the

appliance from the electricity supply:

1. set the FREEZER OPERATION knob on

2. pull the plug out of the socket

Cleaning the appliance

• The external and internal parts, as well as the rubber seals may

be cleaned using a sponge that has been soaked in lukewarm

water and bicarbonate of soda or neutral soap. Do not use

solvents, abrasive products, bleach or ammonia.

• The removable accessories may be soaked in warm water and

soap or dishwashing liquid. Rinse and dry them carefully.

• The back of the appliance may collect dust which can be

removed by delicately using the hose of a vacuum cleaner set

on medium power. The appliance must be switched off and the

plug must be pulled out before cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic materials which are

odour free. In order to maintain an odour free refrigerator and to

prevent the formation of stains, food must always be covered or

sealed properly.

• If you want to switch the appliance off for an extended period of

time, clean the inside and leave the doors open.

Holiday function

If you are going on holiday, you do not have to switch the appliance

off; it features a low-energy function which optimises the

temperature of the refrigerator compartment to suit the products

stored inside it (you may, for example, wish to protect cosmetics

and beauty products from the heat). The freezer temperature must

be set to the minimum value in order to preserve the food.

To enable the function: set the REFRIGERATOR OPERATION knob

on HOLIDAY ( see diagram ).

A double acoustic signal informs you when it has been enabled. A

single acoustic signal informs you when it has been disabled.

Replacing the l Odour filter

The filter should be replaced after approximately 6-8 months from

when it is activated. This period may vary depending on the type of

food that is stored. For information on where a replacement filter may

be purchased, contact Assistance ( see Assistance ).

To replace the filter, follow the instructions ( see diagrams A and B ).

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24

Replacing the light bulb

To replace the light bulb in the refrigerator compartment, pull out

the plug from the electrical socket. Follow the instructions below.

Access the light bulb by removing the cover as indicated in the

diagram. Replace it with a similar light bulb within the power range

indicated on the cover (10W).

Precautions and tips

! The appliance was designed and manufactured in compliance

with international safety standards. The following warnings are

provided for safety reasons and must be read carefully.

This appliance complies with the following Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

amendments;

-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and

subsequent amendments;

- 2002/96/CE.

General safety

• The appliance was designed for domestic use inside the home

and is not intended for commercial or industrial use.

• The appliance must be used to store and freeze food products

by adults only and according to the instructions in this manual.

• The appliance must not be installed outdoors, even in covered

areas. It is extremely dangerous to leave the appliance exposed

to rain and storms.

• Do not touch the appliance with bare feet or with wet or moist

hands and feet.

• Do not touch the internal cooling elements: this could cause skin

abrasions or frost/freezer burns.

• When unplugging the appliance always pull the plug from the

mains socket, do not pull on the cable.

• Before cleaning and maintenance, always switch off the

appliance and disconnect it from the electrical supply. It is not

sufficient to set the temperature adjustment knobs on

(appliance off) to eliminate all electrical contact.