Indesit BIAA 10P UK 사용 설명서 - 페이지 9

{카테고리_이름} Indesit BIAA 10P UK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit BIAA 10P UK 12 페이지. Refrigerator/freezer combination

페이지 인쇄

6. Wait for approximately 2 hours, i.e. until the ideal storage

conditions have been restored, before placing food in the

freezer compartment.

Replacing the light bulb

• We recommend you clean your fridge with our Professional

Fridge cleaner.To order please call us on 08448 225 225 or

visit www.indesitservice.co.uk

To replace the light bulb in the refrigerator compartment, pull out

the plug from the electrical socket. Follow the instructions below.

Access the light bulb by removing the cover as indicated in the

diagram. Replace it with a similar light bulb within the power range

indicated on the cover (10W or 15W).

Precautions and tips

! The appliance was designed and manufactured in compliance

with international safety standards. The following warnings are

provided for safety reasons and must be read carefully.

This appliance complies with the following Community Directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

amendments;

-89/336/EEC of 03.05.89 (Electromagnetic Compatibility) and

subsequent amendments;

- 2002/96/CE..

General safety

• The appliance was designed for domestic use inside the home

and is not intended for commercial or industrial use.

• The appliance must be used to store and freeze food products

by adults only and according to the instructions in this manual.

• The appliance must not be installed outdoors, even in covered

areas. It is extremely dangerous to leave the appliance

exposed to rain and storms.

• Do not touch the appliance with bare feet or with wet or moist

hands and feet.

• Do not touch the internal cooling elements: this could cause

skin abrasions or frost/freezer burns.

• When unplugging the appliance always pull the plug from the

mains socket, do not pull on the cable.

• Before cleaning and maintenance, always switch off the

appliance and disconnect it from the electrical supply. It is

not sufficient to set the temperature adjustment knobs on

(appliance off) to eliminate all electrical contact.

• In the case of a malfunction, under no circumstances should

you attempt to repair the appliance yourself. Repairs carried

out by inexperienced persons may cause injury or further

malfunctioning of the appliance.

• Do not use any sharp or pointed utensils or electrical equipment

- other than the type recommended by the manufacturer - inside

the frozen food storage compartments.

• Do not put ice cubes taken directly from the freezer into your

mouth.

• This appliance is not intended for use by persons (including

children) with reduced physical, sensory or lack of experience

and knowledge unless they have been given supervision

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24

or instruction concerning use of the appliance by a person

responsible for their safety. Children should be supervised to

ensure that they do not play with the appliance.

• Keep packaging material out of the reach of children! It can

become a choking or suffocation hazard.

Disposal

• Observe local environmental standards when disposing

packaging material for recycling purposes.

• The European Directive 2002/96/EC on Waste Electrical and

Electronic Equipment (WEEE), requires that old household

electrical appliances must not be disposed of in the normal

unsorted municipal waste stream. Old appliances must be

collected separately in order to optimise the recovery and

recycling of the materials they contain and reduce the impact

on human health and the environment. The crossed out

"wheeled bin" symbol on the product reminds you of your

obligation, that when you dispose of the appliance it must be

separately collected. Consumers should contact their local

authority or retailer for information concerning the correct

disposal of their old appliance.

Respecting and conserving the environment

• Install the appliance in a fresh and well-ventilated room. Ensure

that it is protected from direct sunlight and do not place it near

heat sources.

• Try to avoid keeping the door open for long periods or opening

the door too frequently in order to conserve energy.

• Do not fill the appliance with too much food: cold air must

circulate freely for food to be preserved properly. If circulation

is impeded, the compressor will work continuously.

• Do not place hot food directly into the refrigerator. The internal

temperature will increase and force the compressor to work

harder and will consume more energy.

• Defrost the appliance if ice forms (see Maintenance). A thick

layer of ice makes cold transference to food products more

difficult and results in increased energy consumption.

• Regularly check the door seals and wipe clean to ensure they

are free of debris and to prevent cold air from escaping (see

Maintenance).

Troubleshooting

If the appliance does not work, before calling for Assistance (see

Assistance), check for a solution from the following list.

The internal light does not illuminate.

• The plug has not been inserted into the electrical socket, or not

far enough to make contact, or there is no power in the house.

The refrigerator and the freezer do not cool well.

• The doors do not close properly or the seals are damaged.

• The doors are opened too frequently.

• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

• The refrigerator or the freezer have been over-filled.

• The atmospheric temperature of the area surrounding the

appliance is lower than 14°C.

The food inside the refrigerator is beginning to freeze.

• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

• The food is in contact with the back inside wall of the

refrigerator.

The AIR fan does not rotate

• The refrigerator door is open.

• The AIR system is only activated automatically when it becomes

necessary to restore perfect operational conditions inside the

refrigerator compartment.

The motor runs continuously.

• The door is not closed properly or is continuously opened.

• The outside ambient temperature is very high.

• The thickness of the frost exceeds 2-3 mm (see Maintenance).