Indesit CA 55 XX 사용 설명서 - 페이지 4

{카테고리_이름} Indesit CA 55 XX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit CA 55 XX 12 페이지. Indesit refrigerator user manual
Indesit CA 55 XX에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

DOOR REVERSAL

Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.

It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated

containers whilst carrying out this operation.

You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original

packaging).

Remove the doors

1. Lay down the appliance on its back.

2. Unscrew, remove and retain the bottom hinge.

3. Slightly open the bottom door and slide downward remove and carefully place to one side

4. Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully

place to one side.

5. Unscrew and remove the top front cover from the cabinet .

6. Unscrew and remove the hinge pin and the bolt from the top right hand and refit them into the hole in the left hand

side. Refit the top front

cover.

7. Use a thin blunt instrument

to remove the top and

bottom hinge bushes and

blanking plugs from the

doors, take care not to

mark the door handle.

Reposition the blanking

plugs and bushes on the

opposite side.

8. Fit the blanking plugs

provided into the right

hand two centre hinge

holes.

Replacing the doors

1. Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the

opposite side.

2. Carefully slide bottom door upward

into the centre hinge pin.

3. Unscrew the bottom hinge pin and

refit it on the opposite side..

4. Fit the bottom hinge making sure that

the door is aligned to the cabinet.

5. Carefully stand the appliance upright

in it's required location and make

sure it is sitting level on the floor.

Open and close the doors checking

that the gasket makes a good seal

without any gaps when the doors are

closed.

Note: Replace loose items/fittings back

into the appliance and leave for at least

15 minutes before switching back on.