Indesit DFG 15B1 사용 설명서 - 페이지 8

{카테고리_이름} Indesit DFG 15B1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit DFG 15B1 28 페이지.
Indesit DFG 15B1에 대해서도 마찬가지입니다: 사용 설명서 (28 페이지), 사용 설명서 (20 페이지)

페이지 인쇄

Electrical Connection

If your appliance is supplied with a 13 amp. fused plug it can

be plugged into a 13 amp socket for immediate use. Before

using the appliance please read the instruction below.

WARNING: THIS APPLIANCE MUST BE EARTHED.

THE FOLLOWING OPERATIONS SHOULD BE CARRIED

OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse

to BS 1362 should always be used, and the fuse cover re-

fitted. If the fuse cover is lost, the plug must not be used until

a replacement is obtained.

Replacemente fuse covers:

If a replacement fuse cover is fitted, it must be of the correct

colours as indicated by the coloured marking or the colour that

is embossed in words on the base of the plug. Replacements

can be obtained directly from your nearest Service Depot.

Removing the plug:

Ifyour appliance has a non-rewireable moulded plug and you

should wish to remove it to re-route the mains cable through

partitions, units etc., please esure that either:

- the plug is replaced by a fused 13 amp re-wireable plug

bearing the BSI mark of approval

- or:

- the mains cable is wired directly into a 13 amp cable outlet,

controlled by a switch, (in compliance with BS 5733) which

is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the

pins unusable so that it cannot be accidentally inserted into

a socket.

Instruction for connecting cable to an altenative

plug:

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow

Blue

Brown

CAUTION:

- Once the appliance has been installed, the electrical plug

and socket should remain accessible.

- The Company shall not be held responsible for any in-

cidents that occur if these regulations are not observed.

- Earth

- Neutral

- Live

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the terminal

in your plug, proceed as follows:

connect Green & Yellow wire to terminal market "E" or

coloured Green or Green & Yellow.

Connect Brown wire to terminal marked "L" or coloured Red.

Connect Blue wire to terminal marked "N" or coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a

13 amp fuse. A15 amp plug must be protected by a 15 amp

fuse, either in the plug or adaptor or at the distribution board.

If you are in any doubt about the electrical supply to your

machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with

the following code:

BLUE

"NEUTRAL" ("N")

BROWN

"LIVE" ("L")

GREEN AND YELLOW

"EARTH" ("E") or

Disposing of the appliance:

When disposing of the appliance please remove the plug by

cutting the mains cable as close as possible to the plug body

and dispose of it as described above.