Indesit DI 6 사용자 지침서 - 페이지 11

{카테고리_이름} Indesit DI 6에 대한 사용자 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit DI 6 12 페이지. Indesit dishwasher installation and use

페이지 인쇄

Installation

Positioning the Appliance

Position the appliance in the desired location. The back

should rest against the wall behind it, and the sides, along

the adjacent cabinets or wall. The dishwasher is equipped

with water supply and drain hoses that can be positioned to

the right or the left to facilitate proper installation.

Levelling the Appliance

Once the appliance is positioned, adjust the feet (screwing

them in or out) to adjust the height of the dishwasher, making

it level. In any case, the appliance should not be inclined

more than 2°.

If the appliance is level, it will help ensure proper perfor-

mance.

Cold Water Connection

Connect the cold water supply hose to a threaded 3/4 (gas)

connector, inserting the small

filter supplied with the

dishwasher and making sure

that it is fastened tightly in place

(see figure 2).

If the water pipes are new or

have not been used for an

extended period of time, let the

water run to make sure that the

water is clear and free of

impurities. If this precaution is

not taken, there is a risk that

the water

inlet can get blocked and damage the

appliance.

Hot Water Connection

The water supply to the appliance can also be connected to

the house's hot water line (centralised system, heating

system), as long as it does not exceed a temperature of

60°C.

In this case, the wash cycle time will be shortened by about

15 minutes and the wash efficiency slightly reduced.

The connection must be made to the hot water line following

the same procedures as those for the connection to the cold

water line.

Drain Hose Connection

Fit the drain pipe into a drain

line with a minimum diameter

of 4 cm or place it over the sink.

Avoid restricting or bending it.

Use the special plastic elbow

provided (see figure) to position

it in the best possible way. The

part of the pipe marked with the

letter A should be between 40

and 100 cm above the ground.

The pipe should not be

immersed in water.

Attention: The special plastic hose support must be solidly

fastened to the wall to prevent the drain hose from moving

and allowing water to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for

the current in the home correspond to those on the rating

plate (located on the stainless steel inner door of the

appliance) and that the electrical system is sized for the

maximum voltage on the rating plate, insert the plug into

an electrical socket which is earthed properly (the earthing

of the appliance is a safety requirement mandated by law).

If the electrical socket to which the appliance must be

connected is not appropriate for the plug, replace the plug,

rather than using adpators or the like as they could cause

overheating and burns.

Caution: the dishwasher plug must be accessible even when

the appliance is installed as a built-in unit so that maintenance

can be done safely.

Should the electricity supply cable be damaged, we

recommend that you only contact authorised Technical Service

Centres for the replacement.

Condensation-proof tape.

On some models, a transparent condensation-proof adhesive

tape has been provided.

It should be stuck onto the lower side of your wooden worktop

to protect it from the formation of condensation.

When not provided, this tape can be requested as a spare

part from authorised retailers.