Indesit DSR 15B3 사용 설명서 - 페이지 13

{카테고리_이름} Indesit DSR 15B3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit DSR 15B3 40 페이지.
Indesit DSR 15B3에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

Detergent and

dishwasher use

Measuring out the detergent

Good washing results also depend on the correct amount of

detergent being used. Exceeding the stated amount does not

result in a more effective wash and increases environmental

pollution.

The amount can be adjusted to the soil level.

In the case of normally soiled items, use approximately either

25g (powder detergent) or 25ml (liquid detergent). If tablets

are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed

with water before being placed in the dishwasher, reduce

the amount of detergent used accordingly.

For good washing results also follow the instructions shown

on the detergent box.

For further questions please ask the detergent producers.

Open the detergent dispenser using button D and measure out

the detergent according to the Table of wash cycles:

1 tablet, place it in compartment A

and close cover C

2 tablets, place the second tablet

on the bottom of the appliance.

Remove detergent residues from

the edges of the compartment and close cover C until it clicks.

The detergent dispenser automatically opens up at the right time

according to the wash cycle.

If all-in-one detergents are used, we recommend using the TABS

option, because it adjusts the cycle so that the best washing and

drying results are always achieved.

Only use detergent which has been specifically designed

for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam residues

remaining in the machine after the cycle has ended.

To achieve the best washing and drying results, the combined

use of detergent, rinse aid liquid and refined salt is required.

We recommend using detergents that do not contain

phosphates or chlorine, as these products are harmful

to the environment.

Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.

3. Open the door and pour in a suitable amount of detergent.

4. Load the racks

Select the wash cycle by turning the WASH CYCLE

SELECT knob clockwise: align the notch in the knob with

the number/symbol representing the desired wash cycle. The

6. Select the wash options

7. Start the cycle by pressing the Start/Pause button: a beep

the indicator light corresponding to the wash

will sound

and

phase will go on to signal that the cycle has begun.

8. At the end a few beeps

and the END indicator light will go on.

9. Wait for a few minutes before removing the crockery - to

The machine will switch off automatically during long

periods of inactivity in order to minimise electricity

consumption.

AUTO WASH CYCLES

the level of soiling and automatically select the most efficient and

economic wash cycle accordingly. The duration of the auto wash

cycles may vary due to the operation of the sensor.

Changing a wash cycle in progress

If a mistake was made in the wash-cycle selection process, it is

possible to change the cycle provided that it has only just begun:

Once the wash cycle has started, in order to change the wash

OFF/Reset button. Switch it back on using the same button and

select the desired wash cycle and options.

Adding extra crockery

Press the Start/Pause button - the corresponding indicator light

will flash. Open the door, taking care to avoid the escaping

steam, and place the crockery inside the appliance. Press the

If the Start/Pause button is pressed so as to pause the

At this stage the wash cycle cannot be changed.

Accidental interruptions

If the door is opened during the wash cycle or there is a power

cut, the cycle stops. It starts again from the point at which it

was interrupted once the door has been shut or the electricity

supply restored.

and shut the door.

will signal the end of the wash cycle

some models of dishwasher are