Indesit DSR 26B17 사용 설명서 - 페이지 23

{카테고리_이름} Indesit DSR 26B17에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit DSR 26B17 28 페이지.

페이지 인쇄

Detergent and

dishwasher use

Measuring out the detergent

Good washing results also depend on the correct amount of

detergent being used. Exceeding the stated amount does not

result in a more effective wash and increases environmental

pollution.

The amount can be adjusted to the soil level.

In the case of normally soiled items, use approximately either

25g (powder detergent) or 25ml (liquid detergent). If tablets

are used, one tablet will be enough.

If the crockery is only lightly soiled or if it has been rinsed

with water before being placed in the dishwasher, reduce

the amount of detergent used accordingly.

For good washing results also follow the instructions shown

on the detergent box.

For further questions please ask the detergent producers.

Open the detergent dispenser using button D and measure out

the detergent according to the Table of wash cycles:

Remove detergent residues from the edges of the compartment

and close cover C until it clicks.

The detergent dispenser automatically opens up at the right time

according to the wash cycle.

If all-in-one detergents are used, we recommend using the TABS

option, because it adjusts the cycle so that the best washing and

drying results are always achieved.

Only use detergent which has been specifically designed

for dishwashers.

DO NOT USE washing up liquid.

Using excessive detergent may result in foam residues

remaining in the machine after the cycle has ended.

To achieve the best washing and drying results, the combined

use of detergent, rinse aid liquid and refined salt is required.

We recommend using detergents that do not contain

phosphates or chlorine, as these products are harmful

to the environment.

Only available in selected models.

• p o w d e r o r l i q u i d :

c o m p a r t m e n t s A ( w a s h

detergent) and B (pre-wash

detergent)

• tablets: when the cycle

requires 1 tablet, place it in

compartment A and close

cover C; when it requires 2

tablets, place the second tablet

on the bottom of the appliance.

Starting the dishwasher

1. Turn the water tap on.

2. Switch on the appliance by pressing the ON/OFF button.

3. Open the door and pour in a suitable amount of detergent

(see Measuring out the detergent).

(see Loading the racks)

4. Load the racks

5. Select the wash cycle by turning the SELECT WASH CYCLE

knob: align the notch on the knob with the number or symbol

representing the desired wash cycle. The START/PAUSE

indicator light will go on.

6. Select the wash options

Cycles).

7. Start the cycle by pressing the START button; the indicator

light will stop flashing and stay lit (fixed light). The indicator light

corresponding to the wash phase will go on, signalling that the

wash cycle has begun.

8. At the end of the wash cycle the END indicator light will go on

(fixed light). Switch off the appliance by pressing the ON/OFF

button, shut off the water tap and unplug the appliance from the

electricity socket.

9. Wait a few minutes before removing the crockery to avoid

getting burnt. Unload the racks, beginning with the lower level.

The machine will switch off automatically during long

periods of inactivity in order to minimise electricity

consumption.

AUTO WASH CYCLES

equipped with a special sensor which can be used to assess

the level of soiling and automatically select the most efficient and

economic wash cycle accordingly. The duration of the auto wash

cycles may vary due to the operation of the sensor.

Changing a wash cycle in progress

If a mistake was made in the wash-cycle selection process, it is

possible to change the cycle provided that it has only just begun:

Once the wash cycle has started, in order to change the wash

cycle switch off the machine by pressing and holding the ON/

OFF/Reset button. Switch it back on using the same button and

select the desired wash cycle and options.

Adding extra crockery

Press the Start/Pause button and open the door, taking care to

avoid the escaping steam. Then place the crockery inside the

dishwasher. Press the Start/Pause button: The cycle will start

again after a long beep has been emitted.

If the delayed start has been set, at the end of the countdown

the wash cycle will not start. It will stay in Pause mode.

Press the Start/Pause button to pause the machine; the wash

cycle is stopped.

At this stage the wash cycle cannot be changed.

Accidental interruptions

If the door is opened during the wash cycle or there is a power

cut, the cycle stops. It starts again from the point at which it

was interrupted once the door has been shut or the electricity

supply restored.

and shut the door.

(see Options and Special Wash

some models of dishwasher are