Indesit DVG 622 설치 및 사용 설명서 - 페이지 6

{카테고리_이름} Indesit DVG 622에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit DVG 622 17 페이지. Indesit dishwasher installation and use
Indesit DVG 622에 대해서도 마찬가지입니다: 운영 지침 (3 페이지), 매뉴얼 (21 페이지)

페이지 인쇄

Detergent and Rinse Aid ....

Detergent

Detergent specifically intended for use with dishwashers

must be used. The dispenser must be refilled before the

start of each wash cycle following the instructions provided

in the "Wash Cycle Table." The detergent dispenser is

located on the inside panel of the door.

Loading the detergent

To open lid "A", press button "B". The cleaning detergent

should be introduced into the two containers "C"and "D"

up to the rim.

After pouring in the detergent, replace the lid, pressing

down until it clicks.

Dishwasher detergent in tablets is now available on the

market, in which case you should place one tablet into

container "D" and replace the lid.

Notice: To facilitate closing the cover, remove any

excess detergent on the edges of the dispenser.

Warning

Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.

If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the

formation of white streaks on your dishes or on the interior of the appliance.

Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.

If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.

In any case, please read the manufacturer's instructions on the packet.

If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number

of cycles.

The rinse aid.

This product makes dishes sparkle more as it improves their

drying. The rinse aid container is situated on the inside of the

door: It should be filled up when the low rinse aid indicator

light "T" flashes.

Loading the Rinse Aid

To open the dispenser, turn the "C" cap in the anti-

clockwise direction and then pour in the rinse aid, making

sure not to overfill. The amount of rinse aid used for each

cycle can be regulated by turning the "F" dose adjustor,

located beneath the "C" cap, with a screwdriver. There are

6 different settings; the normal dosage setting is 4.

Important:

Proper dosage of the rinse aid improves drying.

If drops of water remain on the dishes or spotting occurs,

the dosage adjustor should be turned to a higher setting. If

the dishes have white streaks, turn the dosage adjustor to a

lower setting.