Indesit 7OIF 617 K.A RU 사용 설명서 - 페이지 10

{카테고리_이름} Indesit 7OIF 617 K.A RU에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit 7OIF 617 K.A RU 20 페이지.
Indesit 7OIF 617 K.A RU에 대해서도 마찬가지입니다: 사용 설명서 (24 페이지)

페이지 인쇄

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

! Never use steam cleaners or pressure cleaners on

the appliance.

• The stainless-steel or enamel-coated external

parts as well as the rubber seals may be cleaned

using a sponge that has been soaked in

lukewarm water and neutral soap. If these stains

are difficult to remove, use only specialised

products. After cleaning, rinse and dry

thoroughly. Do not use abrasive powders or

corrosive substances.

• Ideally, the inside of the oven should be cleaned

after each use, when it is still lukewarm. Use hot

water and detergent, rinse and dry with a soft

cloth. Do not use abrasive products.

• The accessories can be washed like everyday

crockery (even in your dishwasher).

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

To clean more thoroughly, you can remove the oven

door.

1. Open the oven door fully

( see diagram )

2. Lift up and turn the small

levers located on the two

hinges ( see diagram )

3. Grip the door on the two

external sides and close it

approximately half way. Then

pull the door towards you

lifting it out of its seat ( see

diagram ).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre ( see Assistance ). We

recommend not using the oven until the seals have

been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the light bulb and replace it with a similar

one: Wattage 25 W, cap E 14.

3. Replace the glass cover ( see diagram ).

Assistance

Communicating:

• appliance model (Mod.)

• serial number (S/N)

This information is found on the data plate located on

the appliance and/or on the packaging.