Indesit BIM 31 K.A B IX GB 사용 설명서 - 페이지 10

{카테고리_이름} Indesit BIM 31 K.A B IX GB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit BIM 31 K.A B IX GB 12 페이지. Oven
Indesit BIM 31 K.A B IX GB에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

Indesit BIM 31 K.A B IX GB 사용 설명서

Maintenance and care

Switching the appliance off

GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in
lukewarm water and neutral soap. If these stains
are difficult to remove, use only specialised
products. After cleaning, rinse and dry
thoroughly. Do not use abrasive powders or
corrosive substances.
• Ideally, the inside of the oven should be cleaned
after each use, when it is still lukewarm. Use hot
water and detergent, rinse and dry with a soft
cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery (even in your dishwasher).
! Never use steam cleaners or pressure cleaners on
the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
To clean more thoroughly, you can remove the oven
door.
10
1.Open the oven door fully
( see diagram )
2.Lift up and turn the small
levers located on the two
hinges ( see diagram )
3.Grip the door on the two
external sides and close it
approximately half way. Then
pull the door towards you
lifting it out of its seat ( see
diagram ).
To replace the door, reverse
this sequence.
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre ( see Assistance ). We
recommend not using the oven until the seals have
been replaced.

Replacing the light bulb

To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar
one: Wattage 25 W, cap E 14.
3. Replace the glass cover ( see diagram ).
! Do not use the oven lamp as/for ambient lighting
Assistance
Communicating:
• appliance model (Mod.)
• serial number (S/N)
This information is found on the data plate located
on the appliance and/or on the packaging.