Indesit BIM 31 K.A B IX GB 사용 설명서 - 페이지 4

{카테고리_이름} Indesit BIM 31 K.A B IX GB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit BIM 31 K.A B IX GB 12 페이지. Oven
Indesit BIM 31 K.A B IX GB에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

Electrical connection

! Ovens with a three-pole power supply cable are

designed to operate with alternated current at the

supply frequency and voltage indicated on the data

plate (at the bottom of the oven dashboard). The

earthing conductor of the cable is the yellow-green

conductor.

Two types of connection are provided:

Connection n° 1

Connecting the power supply cable to the mains.

Fit a normalized plug to the cable, which

corresponds to the load indicated on the data plate;

if the cooker is connected directly to the mains, an

omnipolar circuit-breaker with a minimum opening of

3 mm between the contacts, suitable for the load

indicated and complying with current directives,

must be installed between the appliance and the

mains (the earthing wire must not be interrupted by

the circuit-breaker). The power supply cable must be

positioned so that it does not exceed room

temperature by 50°C at any point of its length.

Before making the connection check that:

• the circuit breakers or fuses of the home system

can support appliance load (see data plate);

• the power supply system has an efficient earthing

connection which complies with the provisions of

current regulations and the law;

• there is easy access to the socket or the

omnipolar circuit-breaker once the cooker has

been installed.

! do not use reducers, adapters or shunts as these

could cause heating or burning.

Connection n° 2

Disposing of the plug.

! THIS APPLIANCE MUST BE EARTHED.

THIS APPLIANCE MUST BE EARTHED.

Ensure that before disposing of the plug itself, you

make the pins unusable so that it cannot be

accidentally inserted into a socket. Instructions for

connecting cable to an alternative plug:

! the wires in the mains lead are coloured in

accordance with the following code:

-Earth

Green & Yellow -Earth

-Earth

Blue

Brown

If the colours of the wires in the mains lead do not

correspond with the coloured markings identifying

the terminals in your plug, proceed as follows.

Connect Green & Yellow wire to terminal marked "E"

or coloured Green or Green & Yellow.

- N e u t r a l

- L i v e

Connect Brown wire to terminal marked "L L L L L " or

coloured Red. Connect Blue wire to terminal marked

"N N N N N " or coloured Black. If a 13 amp plug (BS 1363) is

used it must be fitted with a 13 amp fuse.

A 15 amp plug must be protected by a 15 amp

fuse, either in the plug or adaptor or at the

distribution board.If you are in any doubt about the

electrical supply to your machine, consult a qualified

electrician before use.

How to connect an alternative plug

The wires in this mains

lead are coloured in

accordance with the

following code:

B L U E

B L U E "NEUTRAL" (N)

B L U E

"NEUTRAL" (N)

B R O W N

" L I V E "

( L )

GREEN AND YELLOW

"EARTH" (E)

Disposing of the appliance

When disposing of the appliance please remove the

plug by cutting the mains cable as close as

possible to the plug body and dispose of it as

described above.

! The plug and socket must be easily accessible.

The plug and socket must be easily accessible.

DATA PLATE

width cm 43.5

Dimensions

height cm 32

depth cm 40

Volume

lt. 57

voltage: 230-240V ~ 50/60Hz

Electrical

maximum power absorbed

connections

2250W-2400W

Directive 2002/40/EC on the label

of electric ovens.

Standard EN 50304

ENERGY LABEL

Declared energy consumption for

Forced convection Class – heating

mode: Fan assisted

This appliance conforms to the

following European Economic

Community directives:

- 2006/95/EEC of 12/12/06 (Low

Voltage) and subsequent

amendments;

- 2004/108/EEC of 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments;

- 93/68/EEC of 22/07/93 and

subsequent amendments.

- 2002/96/EC and subsequent

amendments.

GREEN &

YELLOW

13 amp fuse

BROWN

CROSS-BAR

BLUE

CORD GRIP