Indesit FIMS 51 K.A IX S 사용 설명서 - 페이지 10
{카테고리_이름} Indesit FIMS 51 K.A IX S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit FIMS 51 K.A IX S 44 페이지.
Indesit FIMS 51 K.A IX S에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)
페이지 인쇄
Connecting the supply cable to the mains
GB
Install a standardised plug corresponding to the load
indicated on the data plate (see table).
The appliance must be directly connected to the mains using
an omnipolar switch with a minimum contact opening of 3
mm installed between the appliance and the mains. The
switch must be suitable for the charge indicated and must
comply with current electrical regulations (the earthing wire
must not be interrupted by the switch). The supply cable
must be positioned so that it does not come into contact
with temperatures higher than 50°C at any point (the back
panel of the oven, for example).
! The installer must ensure that the correct electrical
connection has been performed and that it is fully compliant
with safety regulations.
Before connecting the appliance to the power supply, make
sure that
• The appliance is earthed and the plug is compliant with
the law.
• The socket can withstand the maximum power of the
appliance, which is indicated on the data plate.
• The voltage is in the range between the values indicated
on the data plate.
• The socket is compatible with the plug of the appliance.
If the socket is incompatible with the plug, ask an
authorised technician to replace it. Do not use extension
cords or multiple sockets.
! Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
! The manufacturer declines any liability should these
safety measures not be observed.
10
APPLIANCE SPECIFICATIONS
width 43.5 cm
Dimensions*
height 32.4 cm
depth 40.6 cm
Volume*
58 l
width 45.5 cm
Dimensions**
height 32.4 cm
depth 40.6 cm
Volume**
60 l
voltage: 220-240 V~ 50/60 Hz
Electrical
(see data plate)
connections
maximum power absorbed 2250 W
Directive 2002/40/EC on the label
of electric ovens. Standard EN 50304
Models with cooling ventilation:
Energy consumption for Natural
ENERGY
convection heating mode:
LAB EL
Convection
Declared energy consumption for
Forced convection Class heating
mode:
Models without cooling ventilation:
Energy consumption for Forced
convection heating mode:
Multi-cooking
Declared energy consumption for
Natural convection Class heating
mode:
This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EEC dated 12/12/06 (Low
Voltage) and subsequent amendments.
- 2004/108/EEC dated 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments.
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2002/96/EC and subsequent
amendments.
- 1275/2008 standby/off mode.
* Only for models with drawn rails.
** Only for models with wire rails.
Multi-cooking
Convection