Indesit FIU20 설치 및 사용 설명서 지침 - 페이지 29

{카테고리_이름} Indesit FIU20에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit FIU20 36 페이지. Indesit electric built in double oven instructions for installation and use

페이지 인쇄

Installation

Electrical Requirements

For your own safety, we recommend that your cooker is installed by a competent

person such as one who is registered with NICEIC (National Inspection Council for

Electrical Installation Contracting). The cooker should be installed in accordance with

the latest edition of the IEE Regulations.

Warning: This appliance must be earthed.

Electrical Connections

The installer must check that the voltage shown at the rating plate corresponds with

the house electricity supply.

The cooker must be supplied via a suitable double pole isolating switch, having a

contact separation of at least 3mm in all poles placed in a readily accessible position

adjacent to the cooker.

If the cooker is to be wired into a connector unit, this may be positioned behind the

cooker providing the following requirements are met:

i) The connector unit must not project from the wall more than 25mm.

ii) The top of the connector must not be more than 130mm above floor level.

Remove the terminal cover at the rear base of the cooker. Pass the cable through the

cable clamp and connect to the appropriate terminals provided.

Allow sufficient cable for any future servicing.

Tighten the screws on the cable clamp and replace the cover.

Make main connections in the connector unit or cooker control unit.

This appliance conforms to B.S. EN 55014 regarding suppression of Radio and

Television reception interference.

A double Pole control switch having a minimum rating of 32 amps should be used to

feed the cooker using a suitably rated cable.

Where a hob is fitted adjacent to or over the cooker, a 45 amp Double Pole control

switch should be used to feed both units via separate suitably rated cables.

We recommend a minimum of 4mm

B.S. 6004 for connection of each appliance.

In all cases adhere to routing details (see fig. 4).

This appliance must not be installed over any other appliance that generates heat

such as a plinth heater

Note: Due to many different types of installation, a mains cable is not

supplied with this product. The installer will fit the correct type and length of

cable.

PVC insulated twin and earth cable conforming to