Indesit I6T52/AUS 사용 설명서 - 페이지 17

{카테고리_이름} Indesit I6T52/AUS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit I6T52/AUS 20 페이지.

페이지 인쇄

1. Control Panel

Care and maintenance

Switching The Appliance Off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

DO NOT TOUCH HOT SURFACES. ALLOW COOKTOP

AND ALL OVEN SURFACES TO COOL COMPLETELY

BEFORE CLEANING.

Cleaning The Appliance

! Do not use abrasive or corrosive detergents such as

stain removers, anti-rust products, powder detergents

or sponges with abrasive surfaces: these may scratch

the surface beyond repair.

! Never use steam cleaners or pressure cleaners on

the appliance.

• It is usually sufficient simply to wash the hob using a

damp sponge and dry it with absorbent kitchen roll.

• The stainless steel or enamel-coated external parts

and the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the

removal of stubborn stains. After cleaning, rinse well

and dry thoroughly. Do not use abrasive powders or

corrosive substances.

• The hob grids, burner caps, flame spreader rings

and burners may be removed to make cleaning

easier; wash them in hot water and non-abrasive

detergent, making sure all burnt-on residue is

removed before drying them thoroughly.

• For hobs with electronic ignition, the terminal part of

the electronic lighting devices should be cleaned

frequently and the gas outlet holes should be

checked for blockages.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with a

soft cloth. Do not use abrasive products.

•

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth.

• Do not use harsh abrasive cleaners or materials, or

metal scrapers to clean the oven door glass since

these can scratch the surface, which may result in

shattering of the glass.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

• Stainless steel can be marked by hard water that

has been left on the surface for a long time, or by

aggressive detergents containing phosphorus.

After cleaning, rinse well and dry thoroughly. Any

remaining drops of water should also be dried.

Inspecting The Oven Seals

Check the door seals around the oven regularly. If

the seals are damaged, please contact your nearest

Authorised After-sales Service Centre. We recommend

that the oven is not used until the seals have been

replaced.

Gas Tap Maintenance

Over time, the taps may become jammed or difficult to

turn. If this occurs, the tap must be replaced.

!This procedure must be performed by a qualified

technician authorised by the manufacturer.

Replacing The Oven Light Bulb

1. After disconnecting the

oven from the electricity mains,

remove the glass lid covering

the lamp socket (see figure).

2. Remove the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W,

cap E 14.

3. Replace the lid and reconnect the oven to the

electricity supply.

Cleaning The Cooktop

 Always wipe spills up when they occur. Do not leave

spills to dry onto the surface of the hob.

 It is usually enough to wash the hob with a damp

sponge and dry it with absorbent kitchen roll.

 NOTE: Do not put hot components in cold water.

The sudden temperature shock could cause the

component to crack.

 Do not use abrasive or corrosive detergents such

as stain removers, anti-rust products, powder

detergents or sponges with abrasive surfaces: these

may scratch the surface beyond repair.