Indesit KN6G660SA /U 사용 설명서 - 페이지 7

{카테고리_이름} Indesit KN6G660SA /U에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit KN6G660SA /U 28 페이지. Cooker and oven

페이지 인쇄

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a full ring showing

the strength of the flame for the relevant burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired

level by turning the BURNER knob in an

anticlockwise direction. This may be the minimum

setting C, the maximum setting E or any position in

between the two.

HOB GAS BURNER

SAFETY DEVICE

If the appliance is fitted with an electronic lighting

device* ( see figure ), press the BURNER knob and

turn it in an anticlockwise direction, towards the

minimum flame setting, until the burner is lit. The

burner may be extinguished when the knob is

released. If this occurs, repeat the operation, holding

the knob down for a longer period of time.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

The appliance is equipped with a flame failure safety

device; press and hold the BURNER knob for

approximately 3-7 seconds to keep the flame alight

and to activate the device.

To switch the burner off, turn the knob until it

reaches the stop position •.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should

also be suited to the size of the burner:

WARNING! The glass lid can break in

if it is heated up. Turn off all the burn-

ers and the electric plates before clos-

ing the lid. *Applies to the models with

glass cover only.

Fast (R)

Semi Fast (S)

Auxiliary (A)

To identify the type of burner, please refer to the

diagrams contained in the "Burner and nozzle

specifications".

Using the oven

! The first time you use your appliance, heat the

empty oven with its door closed at its maximum

temperature for at least half an hour. Ensure that the

room is well ventilated before switching the oven off

and opening the oven door. The appliance may emit

a slightly unpleasant odour caused by protective

substances used during the manufacturing process

burning away.

ELECTRONIC

! Before operating the product, remove all plastic

LIGHTING DEVICE

film from the sides of the appliance.

! Never put objects directly on the bottom of the

oven; this will avoid the enamel coating being

damaged.

! Should the appliance be equipped with an

electronic programmer*, to use the electric oven, just

press buttons

selecting the desired cooking function.

1. Select the desired cooking mode by turning the

SELECTOR knob.

2. Select the recommended temperature for the

cooking mode or the desired temperature by turning

the THERMOSTAT knob.

A list detailing cooking modes and suggested

cooking temperatures can be found in the relevant

table ( see Oven cooking advice table ).

During cooking it is always possible to:

• Change the cooking mode by turning the

SELECTOR knob.

• Change the temperature by turning the

THERMOSTAT knob.

• Stop cooking by turning the SELECTOR knob to

the "0" position.

! Always place cookware on the rack(s) provided.

Only available in certain models.

Burner

ø Cookware diameter (cm)

and

at the same time (the

symbol will appear on the display) before

24 - 26

16 - 20

10 - 14