Indesit IS67G5PHX/UK 매뉴얼 - 페이지 14

{카테고리_이름} Indesit IS67G5PHX/UK에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IS67G5PHX/UK 21 페이지.

페이지 인쇄

CLEANING AND MAINTENANCE

TURN OFF THE MAIN SWITCH AND ENSURE

THE COOKER IS COLD BEFORE CLEANING.

Do not use steam cleaning

equipment.

Use protective gloves during all

operations.

Disconnect the appliance from the power

Respecting and conserving the environment

• Whenever possible, avoid pre-heating the oven

and always try to fill it. Open the oven door as little

as possible because heat is lost every time it is

opened. To save a substantial amount of energy,

simply switch off the oven 5 to 10 minutes before the

end of your planned cooking time and use the heat

the oven continues to generate.

• Keep gaskets clean and tidy to prevent any door

energy losses

• If you have a timed tariff electricity contract, the "delay

cooking" option will make it easier to save money by

moving operation to cheaper time periods.

• The base of your pot or pan should cover the hot plate.

If it is smaller, precious energy will be wasted and

pots that boil over leave encrusted remains that can

be difficult to remove.

• Cook your food in closed pots or pans with well-fitting

lids and use as little water as possible. Cooking with

the lid off will greatly increase energy consumption

• Use purely flat pots and pans

• If you are cooking something that takes a long time,

it's worth using a pressure cooker, which is twice as

fast and saves a third of the energy.

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

The cover

when the burners are alight or when they are still hot.

Gas tap maintenance

Over time, the taps may become jammed or difficult to

turn. If this occurs, the tap must be replaced.

EXTERIOR SURFACES

• Clean the surfaces with a damp microfibre cloth.

If they are very dirty, add a few drops of pH-neutral

detergent. Dry them with a dry cloth.

• Do not use corrosive or abrasive detergents. If any of

these products inadvertently comes into contact with

the surfaces of the appliance, clean immediately with

a damp microfibre cloth.

*Only available in certain models

BEFORE SWITCHING ON AGAIN, ENSURE THAT

ALL CONTROLS ARE IN THE OFF POSITION.

Carry out the required

operations when the oven is cold.

Disconnect the appliance from

the power supply.

supply.

If the cooker is fitted with

a glass cover, this cover

should be cleaned using

lukewarm water. Do not use

abrasive products.

It is possible to remove

the cover in order to make

cleaning the area behind

the hob easier. Open

the cover fully and pull it

upwards (see figure).

! Do not close the cover

Do not use wire wool, abrasive

scourers or abrasive/corrosive

cleaning agents, as these could

damage the surfaces of the

appliance.

MOVING THE TOP HEATING ELEMENT

R emove the side accessory holder grills.

P ull the heating element out a little ( Fig. 1) and

lower it ( Fig. 2 ).

To reposition the heating element, lift it up,

pulling it slightly towards you, making sure it

comes to rest on the lateral support.

Fig. 1

INTERIOR SURFACES

• After every use, leave the oven to cool and then

clean it, preferably while it is still warm, to remove any

deposits or stains caused by food residues To dry any

condensation that has formed as a result of cooking

foods with a high water content, let the oven to cool

completely and then wipe it with a cloth or sponge.

• Clean the glass in the door with a suitable liquid

detergent.

ACCESSORIES

Soak the accessories in a washing-up liquid solution

after use, handling them with oven gloves if they

are still hot. Food residues can be removed using a

washing-up brush or a sponge.

REPLACING THE LIGHT

1. Disconnect the oven

2. Unscrew the cover from the light,

Note: Use 40 W/230 V type

The bulb used in the product is specifically designed for

domestic appliances and is not suitable for general room

lighting within the home (EC Regulation 244/2009).

Light bulbs are available from our After-sales Service.

- Do not handle bulbs with your bare hands as your

fingerprints could damage them. Do not use the oven until

the light cover has been refitted.

Fig. 2

from the power supply

replace the bulb

and screw the cover back on the light.

Reconnect the oven to the power supply.