Indesit IS67G5PHX/UK 매뉴얼 - 페이지 6

{카테고리_이름} Indesit IS67G5PHX/UK에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IS67G5PHX/UK 21 페이지.

페이지 인쇄

WARNING : This operation must be perfomed

by a qualified technician

INSTALLATION

Before moving your cooker check that it is cool, and switch off

at the cooker control unit. Movement of your cooker is most

easily achieved by lifting the front as follows:

Open the grill door sufficiently to allow a comfortable grip on

the underside front edge of the oven roof, avoiding any grill

elements. (Fig.A)

Moving the Cooker

Take care in moving the cooker as it is heavy.

Take care to ensure that any floor covering is not

damaged.

Please keep these operating instructions for future reference. Make

sure that the instructions are kept with the appliance if it is sold,

given away or moved.

Positioning and leveling

This unit may be installed and used only in permanently ventilated

rooms according to the British Standards Codes Of Practice: BS 5440

Part 2. The following requirements must be observed:

a) The cooker should not be installed in a bed sitting room with a

volume of less than 20m3. If it is installed in a room of volume

less than 5m3 an air vent of effective area of 100cm2 is

required, if it is installed in a room of volume between 5m3

and 10m3 a supplementary air vent area of 50cm2 is required,

if the volume exceeds 10m3 no air vent is required. However,

if the room has a door or a window which opens directly to

the outside no air vent is required even when the volume is

between 5m3 and 10m3. The room containing the appliance

must contain an openable window or an acceptable

alternative such as an adjustable louvre or hinged panel

opening direct to outside air.

b) During prolonged use of the appliance you may consider it

necessary to open a window to the outside to improve

ventilation.

c) If there are other fuel burning appliances in the same room,

B.S.5440 Part 2 Current Edition, should, be consulted to

determine the requisite air vent.

Fig. A

For a correct installation of the cooker the following precautions must be

followed:

The height of the cooker can be adjusted by means of adjustable feet in

the base of the product of adjustable feet in the base of the product

(900mm - 915mm). To allow alignment with a worktop of greater than

915mm (max 940mm), longer adjustable feet are provided inside your

new product.

Adjust the feet by tilting the cooker from the side. Then install the

product into position.

NOTE: This appliance must not be fitted on a platform.

The cooker is designed to fit between kitchen cabinets spaced 600mm

apart. The space either side need only be sufficient to allow withdrawal

of the cooker for servicing. It can be used with cabinets one side or both

as well as in a corner setting. It can also be used free-standing. Adjacent

side walls which project above hob level, must not be nearer to the

cooker than 65mm and should be protected by heat resistant material.

Any overhanging surface or cooker hood should not be nearer than

750mm.

a. The cooker may be located in a kitchen, a kitchen/dinner or bed sitting

room, but not in a bathroom or shower room.

b. The hoods must be installed according to the requirements in the

hood handbook (minimum 750mm).

c. The wall behind the cooker, 50mm below and 450mm above, and the

width of the cooker, must be a noncombustible material such as ceramic

wall tiles.

d. The cooker should be secured to the wall behind via a safety chain and

hook. (fig.B)

Fig. B