Indesit IT50L 사용 설명서 - 페이지 5

{카테고리_이름} Indesit IT50L에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IT50L 24 페이지. Indesit it50g s; it50g1 s; it50l s; it50g1; it50l; it50g; itl50g1; itl50gm; itl50ga; itl50gw 50cm free standing gas cooker
Indesit IT50L에 대해서도 마찬가지입니다: 사용 설명서 (24 페이지)

페이지 인쇄

rating of 45 amp. In this case the cable is not

supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you

make the pins unusable so that it cannot be

accidentally inserted into a socket. Instructions for

connecting cable to an alternative plug:

! the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow

- Earth

Blue - Neutral

Brown - Live

If the colours of the wires in the mains lead do not

correspond with the coloured markings identifying

the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked "E E E E E "

or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked "L L L L L " or

coloured Red.

Connect Blue wire to terminal marked "N N N N N " or

coloured Black.

If a 13 amp plug (BS 1363) is used it must be fitted

with a 13 amp fuse. A 15 amp plug must be

protected by a 15 amp fuse, either in the plug or

adaptor or at the distribution board. If you are in any

doubt about the electrical supply to your machine,

consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead

GREEN &

are coloured in accordance

YELLOW

with the following code:

13 amp fuse

BROWN

B L U E

CROSS-BAR

BLUE

B R O W N

B R O W N "LIVE

B R O W N

CORD GRIP

GREEN AND YELLOW

"EARTH

EARTH" ("E E E E E ")

EARTH

Disposing of the appliance

When disposing of the appliance please remove the

plug by cutting the mains cable as close as

possible to the plug body and dispose of it as

described above.

Adapting the cooker to different types of

gas

In order to adapt the cooker to a different type of

gas with respect to the gas for which it was

produced (indicated on the label attached to the lid),

follow these steps:

"NEUTRAL

NEUTRAL

NEUTRAL" ("N N N N N ")

NEUTRAL

LIVE

LIVE" ("L L L L L ")

LIVE

a ) a )

a ) a ) replace the hose holder mounted on the appliance

a )

with that supplied in the bag of "cooker

accessories".

b )Replacing the burner nozzles on the hob:

b )

• remove the grids and slide the burners from their

housings;

• unscrew the nozzles using

a 7 mm socket spanner, and

replace them with nozzles for

the new type of gas (see table

1 "Burner and nozzle

characteristics").

• replace all the components

by repeating the steps in

reverse order.

c ) c ) Minimum regulation of the hob burners:

c ) c )

c )

• turn the tap to minimum;

• remove the knob and

adjust the regulation screw,

which is positioned in or next

to the tap pin, until the flame

is small but steady.

! in the case of liquid gas, the

regulation screw must be

screwed in to the bottom.

• check that the flame does not turn off when you

turn the tap quickly from high to low.

d )Regulating the primary air of the burners:

d )

The primary air of the burners requires no regulation.

Adapting to different types of gas

In order to adapt the oven to a different type of gas

with respect to the gas for which it was

manufactured (indicated on the label), follow these

simple steps:

a) a) a) a) a) Replacing the oven burner nozzle

• open the oven door fully

• pull out the sliding oven bottom