Indesit K3G11S/AUS 사용 설명서 - 페이지 14

{카테고리_이름} Indesit K3G11S/AUS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit K3G11S/AUS 16 페이지. Indesit cookers operating instructions

페이지 인쇄

Care and maintenance

Switching The Appliance Off

AUS

Disconnect your appliance from the electricity supply

before carrying out any work on it.

DO NOT TOUCH HOT SURFACES. ALLOW

COOKTOP AND ALL OVEN SURFACES TO COOL

COMPLETELY BEFORE CLEANING.

Cleaning The Appliance

! Do not use abrasive or corrosive detergents such as

stain removers, anti-rust products, powder detergents or

sponges with abrasive surfaces: these may scratch the

surface beyond repair.

! Never use steam cleaners or pressure cleaners on the

appliance.

• It is usually sufficient simply to wash the hob using a

damp sponge and dry it with absorbent kitchen roll.

• The stainless steel or enamel-coated external parts and

the rubber seals may be cleaned using a sponge that

has been soaked in lukewarm water and neutral soap.

Use specialised products for the removal of stubborn

stains. After cleaning, rinse well and dry thoroughly. Do

not use abrasive powders or corrosive substances.

• The hob grids, burner caps, flame spreader rings and

burners may be removed to make cleaning easier;

wash them in hot water and non-abrasive detergent,

making sure all burnt-on residue is removed before

drying them thoroughly.

• For hobs with electronic ignition, the terminal part of the

electronic lighting devices should be cleaned

frequently and the gas outlet holes should be checked

for blockages.

• The inside of the oven should ideally be cleaned after

each use, while it is still lukewarm. Use hot water and

detergent, then rinse well and dry with a soft cloth. Do

not use abrasive products.

•

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth.

• Do not use harsh abrasive cleaners or materials,

or metal scrapers to clean the oven door glass

since these can scratch the surface, which may

result in shattering of the glass.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

• Stainless steel can be marked by hard water that has

been left on the surface for a long time, or by

aggressive detergents containing phosphorus. After

cleaning, rinse well and dry thoroughly. Any remaining

drops of water should also be dried.

Inspecting The Oven Seals

Check the door seals around the oven regularly. If the

seals are damaged, please contact your nearest

Authorised After-sales Service Centre. We recommend

that the oven is not used until the seals have been

replaced.

Gas Tap Maintenance

Over time, the taps may become jammed or difficult to

turn. If this occurs, the tap must be replaced.

!This procedure must be performed by a qualified

technician authorised by the manufacturer.

Replacing The Oven Light Bulb

1. After disconnecting the oven

from the electricity mains, remove

the glass lid covering the lamp

socket ( see figure ).

2. Remove the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W, cap

E 14.

3. Replace the lid and reconnect the oven to the electricity

supply.

Cleaning The Cooktop

• Always wipe spills up when they occur. Do not

leave spills to dry onto the surface of the hob.

• It is usually enough to wash the hob with a damp

sponge and dry it with absorbent kitchen roll.

• NOTE: Do not put hot components in cold water.

The sudden temperature shock could cause the

component to crack.

• Do not use abrasive or corrosive detergents such

as stain removers, anti-rust products, powder

detergents or sponges with abrasive surfaces:

these may scratch the surface beyond repair.