Indesit K6G21/P 사용 설명서 - 페이지 9

{카테고리_이름} Indesit K6G21/P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit K6G21/P 33 페이지. Cooker and oven

페이지 인쇄

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant

burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired level

by turning the BURNER knob in an anticlockwise

direction. This may be the minimum setting C, the

maximum setting E or any position in between the two.

If the appliance is fitted with an electronic lighting

device* (see fi gure), press the

ignition button, marked with

the symbol

BURNER knob down and turn

it in an anticlockwise direction,

towards the maximum flame

setting, until the burner is lit.The

burner may be extinguished

when the knob is released. If this occurs, repeat the

operation, holding the knob down for a longer period of

time.

! If the flame is accidentally extinguished, switch off the

burner and wait for at least 1 minute before attempting

to relight it.

If the appliance is equipped with a flame failure

safety device*, press and hold the BURNER knob for

approximately 2-3 seconds to keep the flame alight

and to activate the device.

To switch the burner off, turn the knob until it reaches

•.

the stop position

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas consumed, it

is recommended that only pans that have a lid and a flat

base are used. They should also be suited to the size of

the burner.

WARNING! The glass lid can break in if

it is heated up. Turn off all the burners

and the electric plates before closing

the lid. *Applies to the models with glass

cover only.

, then hold the

Burner

ř Cookware diameter (cm)

Rapid (R)

Semi-Rapid (S)

Auxilliary (A)

To identify the type of burner, please refer to the diagrams

contained in the "Burner and nozzle specifications".

! On the models supplied with a reducer shelf, remember

that this should be used only for the auxiliary burner when

you use casserole dishes with a diameter under 12 cm.

Using the oven

! The first time you use your appliance, heat the empty

oven with its door closed at its maximum temperature for

at least half an hour. Ensure that the room is well ventilated

before switching the oven off and opening the oven door.

The appliance may emit a slightly unpleasant odour caused

by protective substances used during the manufacturing

process burning away.

! Never put objects directly on the bottom of the oven; this

will avoid the enamel coating being damaged.

Lighting the oven

To light the oven burner, bring a flame or gas lighter close to

opening F (see fi gure) and press the OVEN control knob while

turning it in an anticlockwise direction until it reaches the

MAX position.

If the appliance is fitted with an electronic lighting device*

(see figure), simply press the

OVEN control knob and turn it in an

anticlockwise direction, towards the

MAX position, until the burner is lit.

If, after 15 seconds, the burner is still

not alight, release the knob, open

the oven door and wait for at least 1

minute before trying to light it again. If

there is no electricity the burner may be lit using a flame or a

lighter, as described above.

! The oven is fitted with a safety device and it is therefore

necessary to hold the OVEN control knob down for

approximately 6 seconds.

! If the flame is accidentally extinguished, switch off the

burner and wait for at least 1 minute before attempting to

relight the oven.

Only available in certain models.

24 - 26

16 - 20

10 - 14