Indesit KD3C1E 설치 및 사용 설명서 지침 - 페이지 4

{카테고리_이름} Indesit KD3C1E에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit KD3C1E 32 페이지. 50cm free standing electric cooker

페이지 인쇄

Installation

Siting the Cooker

150 mm

WARNING – THIS APPLIANCE MUST BE EARTHED.

Your cooker should have been checked to ensure that the

voltage corresponds with your supply voltage, this is stated

on the rating plate, which is situated on the rear panel.

The cooker must be connected by a competent person,

such as one who is a NICEIC registered contractor, to a suit-

able double-pole control unit with a minimum rating of

32A and a minimum contact clearance of 3mm (applicable

to newer properties, older properties where a 30A double

pole control unit and a minimum contact clearance of

3mm is acceptable).

The double pole control unit should be fitted adjacent to

the cooker, in accordance with IEE regulations. The control

unit must be within 2 metres of, but not directly above the

appliance and should be easily accessible in the event of

an emergency.

The power supply cable should conform to B.S.6004 with a

conductor size of 6mm

This appliance conforms to EN 55014 regarding

suppression of radio and television interference.

Access to the mains terminals is gained by removing the

rear access cover.

The mains cable must pass through the cable clamp

adjacent to the terminal block. Sufficient cable should be

used to allow the cooker to be pulled out for

servicing.

Ensure that the mains cable is routed away from any

brackets affixed to the rear panel and is not trapped to the

rear

position between cabinets.

The height of the cooker can be adjusted by means of

adjustable feet in the plinth (900mm - 915mm). Adjust the

feet by tilting the cooker from the side. Then install the

product into position.

NOTE: This appliance must not be fitted on a platform.

The cooker is designed to fit between kitchen

cabinets spaced 500mm apart. The space either side need

150 mm

only be sufficient to allow withdrawal of the

cooker for servicing. It can be used with cabinets one side

or both as well as in a corner setting. It can also be used

free-standing.

Adjacent side walls which project above hob level, must

not be nearer to the cooker than 150mm and should be

protected by heat resistant material. Any overhanging

surface or cooker hood should not be nearer than 650mm.

minimum.

wall

when

pushing

the

cooker

into