Indesit KDP60G 설치 및 사용 설명서 지침 - 페이지 27
{카테고리_이름} Indesit KDP60G에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit KDP60G 32 페이지. Free standing gas cooker
Indesit KDP60G에 대해서도 마찬가지입니다: 사용 설명서 (24 페이지), 사용 설명서 (24 페이지)
페이지 인쇄
Installation
UNPACKING THE COOKER
Unpack the components from inside the grill and oven.
Check that the following parts are present:
Grill pan and grid
Pan supports
Enamelled burner caps (4)
Aluminium burner bodies(4)
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)
Each burner requires the injector to be replaced and bypass screws adjusted or
replaced as follows:
1.
Remove the loose hotplate burner parts.
2.
Using a 7mm socket, replace the hotplate injectors as appropriate (see table
on previous page).
3.
Re-position the loose burner parts.
4.
Remove the enamelled baffle at the front of the grill (2 screws).
5.
Remove the screw on the right hand side of the burner and gently slide the
burner off the injector.
6.
Using a 7mm socket, replace the grill injector as appropriate (see table on
previous page).
7.
Re-assemble the burner and baffle.
8.
Inside the top oven, remove the central screw securing the burner retainer.
Slide the retainer to the right slightly and lift away.
9.
Lift the burner assembly and place on the floor of the oven to the right of the
burner opening.
10. Using a 7mm socket, replace the oven injector as appropriate (see table on
previous page).
11. Re-assemble the oven burner and retainer.
12. Replace the main oven injector following the same procedure as for the top
oven.
13. Carefully pull off the control knobs.
14. Using a narrow flat bladed screwdriver rotate the bypass screws fully
clockwise. The main oven thermostat bypass screw is located on the body of
the thermostat below the spindle, the top oven thermostat bypass screw is
located on the body of the thermostat to the right of the spindle and the
hotplate tap bypass screws are located down the centre of the spindle.
15. Re-assemble the control panel parts.
16. Secure the self-adhesive LPG conversion label over the gas details on the data
badge.
Top oven/grill shelf heat shield
Main oven shelves (2)
Top oven/grill shelf (1)
Literature
continued...
27