Indesit BIWDIL7125 사용자 설명서 - 페이지 4

{카테고리_이름} Indesit BIWDIL7125에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit BIWDIL7125 15 페이지.
Indesit BIWDIL7125에 대해서도 마찬가지입니다: 빠른 매뉴얼 (4 페이지)

페이지 인쇄

FUNCTIONS

- If the selected option is not compatible with the set wash cycle, the

indicator light will flash and the option will not be activated.

- If the selected option is not compatible with another previously

selected option, the indicator light will flash accompanied by a buzzer,

and only the latter option will be activated; the indicator light

corresponding to the activated option will turn on.

Stain removal

This option allows for selecting the type of dirt so as to optimally adjust the

cycle for removing the stains. The following types of dirt can be selected:

Food: for stains caused by foodstuffs and beverages, for example.

Work: for grease and ink stains, for example.

Outdoor: for mud and grass stains, for example.

! The wash cycle duration varies according to the type of selected dirt.

Slow Spin

By selecting this function, reduces the spin speed.

Extra rinse

By selecting this option, the efficiency of the rinse is increased and

optimal detergent removal is guaranteed. It is particularly useful for

sensitive skin.

Temperature

40°

60°

Each wash cycle has a pre-defined temperature. To modify the

temperature, press the

button.

40°

60°

Bleaching

If you wish to bleach the laundry, load the washing machine and set the

programme

Start the machine and wait for it to complete the first water filling cycle

(roughly 2 minutes). Put the machine in pause mode by pressing the

"START/PAUSE" button

, open the detergent drawer and pour the

bleach (observe the recommended doses indicated on the package) into

the wash compartment where the partition was previously mounted.

Restart the cycle by pressing the "START/PAUSE" button

If desired, it is possible to add fabric softener into the appropriate

compartment of the detergent drawer.

Drying

Drying may be set as follows:

- Based on the desired laundry dryness level:

Iron "

": suitable for clothes which will need ironing afterwards. the

remaining dampness softens creases, making them easier to remove.

Hanger "

": ideal for clothes which do not need to be dried fully.

Cupboard " ": suitable for laundry which can be put back in a cupboard

without being ironed.

- Based on a set time period: between 40 and 180 minutes.

If your laundry load to be washed and dried is much greater than the

maximum stated load, perform the wash cycle, and when the cycle is

complete, divide the garments into groups and put some of them back

in the drum. At this point, follow the instructions provided for a "Drying

only" cycle. Repeat this procedure for the remainder of the load. A

cooling-down period is always added to the end of each drying cycle.

Drying only

Press button

to perform the drying-only cycle.

After selecting the desired cycle (compatible with the type of garments),

press button

to exclude the washing phase and start the drying phase

at the maximum level for the selected cycle.

Push & Go

This function makes it possible to start an automatic wash and drying

cycle either when the machine is off without having to press the ON/OFF

button in advance, or after switching on the machine without having

activated any button and/or selector (otherwise the Push & Go function

will be deactivated). To start the Push & Go cycle press and hold the

button for 2 seconds. The indicator lights up to show that the cycle has

started. The wash and drying cycle is ideal for cotton or synthetic fabrics,

as it washes them at a temperature of 30° and a maximum spin speed of

1000 rpm. During the drying cycle the maximum temperature is 60°C. At

the end of the cycle the residual humidity will be the same as for the "

level. Max recommended load 3,5 kg. (Cycle duration 210').

How does it work?

1. Load the laundry (cotton and/or synthetic garments) and close the

door.

2. Pour the detergent and/or additives.

3. Start the cycle by pressing and holding the Push & Go button for 2

seconds. The relevant indicator light will turn green and the door will lock

(the DOOR LOCKED symbol is lit).

NB: starting the cycle through the Push & Go button activates an

automatic non-customisable wash and drying cycle recommended for

cotton and synthetic fabrics.

4. The automatic cycle can be used only for washing, excluding the drying

phase. Press the Push & Go button and then the drying button

drying icon of the "

" level will switch off. Maximum load for washing-

only is 4 kg (Cycle duration 45'). The cycle cannot be customised further.

To open the door while an automatic cycle is under way, press the START/

PAUSE button. If the DOOR LOCKED symbol is off, the door may be

opened only during the washing phase. Press the START/PAUSE button

again to restart the wash cycle from the point at which it was interrupted.

5. Once the programme is finished, the END indicator light turns on.

TIPS AND SUGGESTIONS

Divide the laundry according to:

Type of fabric (cotton, mixed fibres, synthetics, wool, garments to be

hand-washed). Colour (separate coloured garments from whites, wash

new coloured garments separately). Delicates (small garments – such as

nylon stockings – and items with hooks – such as bras: insert them in a

fabric bag).

Empty the pockets:

Objects such as coins or lighters can damage the washing machine and

the drum. Check all buttons.

CARE AND MAINTENANCE

Before performing cleaning and maintenance, switch the washing machine

off and disconnect it from the mains power. Do not use flammable liquids to

clean the washing machine.

Disconnect the water and power supplies

Close the water tap after every wash. This will limit wear on the hydraulic

system inside the washing machine and help to prevent leaks.

Unplug the washing machine when cleaning it and during all

maintenance work.

Clean the washing machine

The outer parts and rubber components of the appliance can be cleaned

using a soft cloth soaked in lukewarm soapy water. Do not use solvents or

abrasives.

The washing machine has a "Auto-clean" cycle for its internal parts; it must

be run without any load in the drum.

To optimise this cycle, it is possible to use either detergent (10% of the

quantity specified for lightly soiled garments) or special additives to clean

the washing machine. We recommend running a cleaning cycle every 40

wash cycles.

To start the cycle press buttons

The cycle will start automatically and will run for about 70 minutes. To

stop the cycle, press the START/PAUSE

Care for the door and drum

Always leave the porthole door ajar in order to prevent unpleasant odours

from forming.

LOAD BALANCING SYSTEM

Before every spin cycle, to avoid excessive vibrations before every

spin and to distribute the load in a uniform manner, the drum rotates

continuously at a speed which is slightly greater than the washing

rotation speed. If, after several attempts, the load is not balanced

correctly, the machine spins at a reduced spin speed. If the load is

excessively unbalanced, the washing machine performs the distribution

process instead of spinning. To encourage improved load distribution and

balance, we recommend small and large garments are mixed in the load.

TRANSPORT AND HANDLING

Do not lift the washing machine by gripping it from the upper section.

Unplug the appliance and close the water tap. Check that the door and

detergent dispenser drawer are tightly closed. Detach the filling hose

from the water tap then detach the drain hose. Empty all the water

remaining in the hoses and secure the latter so that they do not get

damaged during transport. Apply the transport bolts back on. Repeat, in

reverse order, the transport bolt removal procedure described in the

"Health & Safety and Installation Guides".

: the

and

simultaneously for 5 seconds.

button.