Indesit EWDE 7145 사용 설명서 지침 - 페이지 10

{카테고리_이름} Indesit EWDE 7145에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit EWDE 7145 16 페이지.

페이지 인쇄

How to run a wash cycle or a

drying cycle

1. SWITCH THE MACHINE ON. Press the

the START/PAUSE indicator light will flash slowly in a

green colour.

2. LOAD THE LAUNDRY. Open the porthole door.

Load the laundry, making sure you do not exceed

the maximum load value indicated in the table of

programmes on the following page.

3. MEASURE OUT THE DETERGENT. Pull out the

detergent dispenser drawer and pour the detergent into

the relevant compartments as described in "Detergents

and laundry".

4. CLOSE THE DOOR.

5. SELECT THE WASH CYCLE. Set the WASH CYCLE

knob to the desired programme; a temperature and

spin speed is set for each wash cycle; these may be

adjusted. The duration of the cycle will appear on the

display.

6. CUSTOMISE THE WASH CYCLE. Use the relevant

buttons:

Modifying the temperature and/or spin speed.

The machine automatically displays the maximum

temperature and spin speed values set for the selected

cycle, or the most recently-used settings if they are

compatible with the selected cycle. The temperature

can be decreased by pressing the

the cold wash "OFF" setting is reached. The spin

speed may be progressively reduced by pressing

the

button, until it is completely excluded (the

"OFF" setting). If these buttons are pressed again, the

maximum values are restored.

Exception: if the 2 programme is selected, the tempe-

rature can be increased up to a value of 60°C.

Setting the drying cycle

The first time the button is pressed, the machine will

automatically select the maximum drying cycle which is

compatible with the selected wash cycle. Subsequent

presses will decrease the drying level and then the

drying time, until the cycle is excluded completely

("OFF").

Drying may be set as follows:

A- Based on the desired laundry dryness level:

Iron dry: suitable for clothes which will need ironing

afterwards. the remaining dampness softens creases,

making them easier to remove; "A1" appears on the

display.

Hanger dry: ideal for clothes which do not need to be

dried fully; "A2" appears on the display.

Cupboard dry: suitable for laundry which can be put

back in a cupboard without being ironed; "A3" appears

on the display.

Extra dry: suitable for garments which need to be dried

completely, such as sponges and bathrobes "A4";

appears on the display.

button;

button, until

7. START THE PROGRAMME. Press the START/PAUSE

8. THE END OF THE WASH CYCLE. This will be

If you wish to cancel a cycle which has already begun,

press and hold the

and the machine will switch off.

B - Based on a set time period: between 30 and 180

minutes.

If your laundry load to be washed and dried is much

greater than the maximum stated load (see adjacent

table), perform the wash cycle, and when the cycle

is complete, divide the garments into groups and put

some of them back in the drum. At this point, follow the

instructions provided for a "Drying only" cycle. Repeat

this procedure for the remainder of the load.

N.B: a cooling-down period is always added to the end

of each drying cycle.

Drying only

Use the cycle selector knob to select a drying cycle

(15-16) in accordance with the type of fabric. The

desired drying level or time may also be set using the

DRYING button

Modifying the cycle settings.

• Press the button to enable the option; the indicator

light corresponding to the button will switch on.

• Press the button again to disable the option; the

indicator light will switch off.

If the selected option is not compatible with the

programmed wash cycle, the indicator light will flash

and the option will not be activated.

If the selected option is not compatible with another

option which has been selected previously, the indicator

light corresponding to the first option selected will

flash and only the second option will be activated; the

indicator light corresponding to the enabled option will

remain lit.

The options may affect the recommended load value

and/or the duration of the cycle.

button. The corresponding indicator light will become

green, remaining lit in a fixed manner, and the door will

be locked (the DOOR LOCKED symbol

To change a wash cycle while it is in progress, pause

the Washer-dryer using the START/PAUSE button (the

START/PAUSE indicator light will flash slowly in an

orange colour); then select the desired cycle and press

the START/PAUSE button again. To open the door while

a cycle is in progress, press the START/PAUSE button;

if the DOOR LOCKED

symbol is switched off the door

may be opened (wait approximately 3 minutes). Press

the START/PAUSE button again to restart the wash

cycle from the point at which it was interrupted.

indicated by the text "End" on the display; when the

DOOR LOCKED

symbol switches off the door may be

opened (wait approximately 3 minutes). Open the door,

unload the laundry and switch off the machine.

button. The cycle will be stopped

will be on).