Indesit IWDE 7145 K 사용 설명서 지침 - 페이지 8

{카테고리_이름} Indesit IWDE 7145 K에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IWDE 7145 K 16 페이지. Washer-dryer
Indesit IWDE 7145 K에 대해서도 마찬가지입니다: 사용 설명서 지침 (17 페이지), 사용 설명서 지침 (16 페이지), 사용 설명서 지침 (16 페이지), 사용 설명서 지침 (16 페이지), 사용 설명서 지침 (48 페이지), 사용 설명서 지침 (16 페이지)

페이지 인쇄

How to run a wash cycle or a

drying cycle

1. SWITCH THE MACHINE ON. Press the

button; the START/PAUSE indicator light will flash

slowly in a green colour.

2. LOAD THE LAUNDRY. Open the porthole door.

Load the laundry, making sure you do not exceed

the maximum load value indicated in the table of

programmes on the following page.

3. MEASURE OUT THE DETERGENT. Pull out the

detergent dispenser drawer and pour the detergent

into the relevant compartments as described in

"Detergents and laundry".

4. CLOSE THE DOOR.

5. SELECT THE WASH CYCLE. Set the WASH

CYCLE knob to the desired programme; a

temperature and spin speed is set for each wash

cycle; these may be adjusted. The duration of the

cycle will appear on the display.

6. CUSTOMISE THE WASH CYCLE. Use the

relevant buttons:

Modifying the temperature and/or spin

speed. The machine automatically displays the

maximum temperature and spin speed values set

for the selected cycle, or the most recently-used

settings if they are compatible with the selected

cycle. The temperature can be decreased by

pressing the

setting is reached. The spin speed may be

progressively reduced by pressing the

until it is completely excluded (the "OFF" setting). If

these buttons are pressed again, the maximum

values are restored.

Setting the drying cycle

The first time the button is pressed, the machine

will automatically select the maximum drying cycle

which is compatible with the selected wash cycle.

Subsequent presses will decrease the drying level

and then the drying time, until the cycle is excluded

completely ("OFF").

Drying may be set as follows:

A- Based on the desired laundry dryness level:

Iron dry: suitable for clothes which will need

ironing afterwards. the remaining dampness softens

creases, making them easier to remove; "A1"

appears on the display.

Hanger dry: ideal for clothes which do not need to

be dried fully; "A2" appears on the display.

Cupboard dry: suitable for laundry which can be

put back in a cupboard without being ironed; "A3"

appears on the display.

Extra dry: suitable for garments which need to be

dried completely, such as sponges and bathrobes

"A4"; appears on the display.

B - Based on a set time period: between 30 and

180 minutes.

button, until the cold wash "OFF"

If your laundry load to be washed and dried is

much greater than the maximum stated load (see

adjacent table), perform the wash cycle, and when

the cycle is complete, divide the garments into

groups and put some of them back in the drum. At

this point, follow the instructions provided for a

"Drying only" cycle. Repeat this procedure for the

remainder of the load.

N.B: a cooling-down period is always added to the

end of each drying cycle.

Drying only

Use the cycle selector knob to select a drying cycle

(11-12) in accordance with the type of fabric. The

desired drying level or time may also be set using

the DRYING button

• Press the button to enable the option; the

indicator light corresponding to the button will

switch on.

• Press the button again to disable the option; the

indicator light will switch off.

If the selected option is not compatible with the

programmed wash cycle, the indicator light will

flash and the option will not be activated.

If the selected option is not compatible with

another option which has been selected previously,

the indicator light corresponding to the first option

selected will flash and only the second option will be

activated; the indicator light corresponding to the

enabled option will remain lit.

button,

The options may affect the recommended load

value and/or the duration of the cycle.

7. START THE PROGRAMME. Press the START/

PAUSE button. The corresponding indicator light will

become green, remaining lit in a fixed manner, and

the door will be locked (the DOOR LOCKED

symbol

it is in progress, pause the Washer-dryer using the

START/PAUSE button (the START/PAUSE indicator

light will flash slowly in an orange colour); then

select the desired cycle and press the START/

PAUSE button again. To open the door while a

cycle is in progress, press the START/PAUSE

button; if the DOOR LOCKED

off the door may be opened. Press the START/

PAUSE button again to restart the wash cycle from

the point at which it was interrupted.

8. THE END OF THE WASH CYCLE. This will be

indicated by the text "End" on the display; when

the DOOR LOCKED

may be opened. Open the door, unload the laundry

and switch off the machine.

If you wish to cancel a cycle which has already

begun, press and hold the

stopped and the machine will switch off.

Modifying the cycle settings.

will be on). To change a wash cycle while

symbol is switched

symbol switches off the door

button. The cycle will be