Indesit PWDE 91473 S 사용 설명서 지침 - 페이지 8

{카테고리_이름} Indesit PWDE 91473 S에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit PWDE 91473 S 16 페이지. Indesit washer/dryer user manual

페이지 인쇄

How to run a wash cycle or a

drying cycle

1. SWITCH THE MACHINE ON. Press the

the START/PAUSE indicator light will flash slowly in a

blue colour.

2. LOAD THE LAUNDRY. Open the porthole door.

Load the laundry, making sure you do not exceed

the maximum load value indicated in the table of

programmes and wash cycles on the following page.

3. MEASURE OUT THE DETERGENT. Pull out the

detergent dispenser drawer and pour the detergent into

the relevant compartments as described in "Detergents

and laundry".

4. CLOSE THE DOOR.

5. SELECT THE WASH CYCLE. Use the WASH CYCLE

SELECTOR knob to select the desired wash cycle. A

temperature and spin speed is set for each wash cycle;

these values may be adjusted. The duration of the cycle

will appear on the display.

6. CUSTOMISE THE WASH CYCLE. Use the relevant

buttons:

Modify the temperature and/or spin

speed. The machine automatically displays the

maximum temperature and spin speed values set for

the selected cycle, or the most recently-used settings

if they are compatible with the selected cycle. The

temperature can be decreased by pressing the

button, until the cold wash "OFF" setting is reached.

The spin speed may be progressively reduced by

pressing the

(the "OFF" setting). If these buttons are pressed again,

the maximum values are restored.

Setting the drying cycle

The first time the button

will automatically select the maximum drying cycle

which is compatible with the selected wash cycle.

Subsequent presses will decrease the drying level

and then the drying time, until the cycle is excluded

completely ("OFF"). If these buttons are pressed again,

the maximum values are restored.

Drying may be set as follows:

A- Based on the desired laundry dryness level:

Iron: suitable for clothes which will need ironing

afterwards. the remaining dampness softens creases,

making them easier to remove. "A1" appears on the

display.

Hanger: ideal for clothes which do not need to be dried

fully. "A2" appears on the display.

Cupboard: suitable for laundry which can be put back

in a cupboard without being ironed. "A3" appears on

the display.

Extra: suitable for garments which need to be dried

completely, such as sponges and bathrobes. "A4"

appears on the display.

B - Based on a set time period: between 30 and 180

minutes (Max. load 4 kg).

button, until it is completely excluded

is pressed, the machine

button;

If your laundry load to be washed and dried is much

greater than the maximum stated load (see adjacent

table of programmes), perform the wash cycle, and

when the cycle is complete, divide the garments into

groups and put some of them back in the drum. At this

point, follow the instructions provided for a "Drying

only" cycle. Repeat this procedure for the remainder of

the load.

A cooling-down period is always added to the end of

each drying cycle.

Drying only

Use the cycle selector knob to select a drying cycle

(11-12-13) in accordance with the type of fabric. The

desired drying level or time may also be set using the

DRYING button

• Press the button to enable the option; the indicator light

corresponding to the button will switch on.

• Press the button again to disable the option; the

indicator light will switch off.

If the selected option is not compatible with the set

wash cycle, the indicator light will flash and the option

will not be activated.

If the selected option is not compatible with

a previously selected one, the indicator light

corresponding to the first function selected will flash and

only the second option will be activated; the indicator

light for the option which has been activated will be

illuminated.

Note: if the SMART option has been selected, none of

the incompatible options may be activated.

The options may affect the recommended load value

and/or the duration of the cycle.

7. START THE WASH CYCLE. Press the START/

PAUSE button. The corresponding indicator light will

turn blue, remaining lit in a fixed manner, and the door

will be locked (the DOOR LOCKED

To change a wash cycle while it is in progress, pause

the washer-dryer using the START/PAUSE button

(the START/PAUSE indicator light will flash slowly in an

amber colour); then select the desired cycle and press

the START/PAUSE button again. To open the door while

a cycle is in progress, press the START/PAUSE button;

if the DOOR LOCKED

may be opened. Press the START/PAUSE button again

to restart the wash cycle from the point at which it was

interrupted.

8. THE END OF THE WASH CYCLE. This will be

indicated by the text "END" on the display; when the

DOOR LOCKED

opened. Open the door, unload the laundry and switch

off the machine.

If you wish to cancel a cycle which has already begun,

press and hold the

and the machine will switch off.

Modify the cycle settings.

symbol will be lit).

symbol is switched off the door

symbol switches off the door may be

button. The cycle will be stopped