Indesit IP 640 S 사용 설명서 - 페이지 9

{카테고리_이름} Indesit IP 640 S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IP 640 S 40 페이지.

페이지 인쇄

Installation

! Before operating your new appliance please read this

instruction booklet carefully. It contains important information

for safe use, installation and care of the appliance.

! Please keep these operating instructions for future reference.

Pass them on to possible new owners of the appliance.

Positioning

! Keep packaging material out of the reach of children. It can

become a choking or suffocation hazard (see Precautions

and tips).

! The appliance must be installed by a qualified professional

according to the instructions provided. Incorrect installation

may cause harm to people and animals or may damage

property.

! This unit may be installed and used only in permanently

ventilated rooms in accordance with current national

regulations. The following requirements must be observed:

• The room must be equipped with an air extraction system

that expels any combustion fumes. This may consist of

a hood or an electric fan that automatically starts each

time the appliance is switched on.

In a chimney stack or branched flue.

(exclusively for cooking appliances)

• The room must also allow proper air circulation, as air is

needed for combustion to occur normally. The flow of air

must not be less than 2 m

The air circulation system may

take air directly from the outside

by means of a pipe with an inner

cross section of at least 100 cm

the opening must not be vulnerable

to any type of blockages.

Examples of

ventilation holes

for comburant air.

The system can also provide the air

Adjacent

Room to be

needed for combustion indirectly,

Room

Vented

i.e. from adjacent rooms fitted with

air circulation tubes as described

above. However, these rooms must

not be communal rooms, bedrooms

or rooms that may present a fire

Enlarging the ventilation slot

between window and floor.

hazard.

• Liquid petroleum gas sinks to the floor as it is heavier

than air. Therefore, rooms containing LPG cylinders must

also be equipped with vents to allow gas to escape in

the event of a leak. As a result LPG cylinders, whether

partially or completely full, must not be installed or stored

Directly to

the Outside

/h per kW of installed power.

in rooms or storage areas that are below ground level

(cellars, etc.). It is advisable to keep only the cylinder

being used in the room, positioned so that it is not subject

to heat produced by external sources (ovens, fireplaces,

stoves, etc. ) which could raise the temperature of the

cylinder above 50°C.

Fitting the appliance

The following precautions must be taken when installing

the hob:

• Kitchen cabinets adjacent to the appliance and taller than

the top of the hob must be at least 600 mm from the edge

of the hob (see figure).

• Hoods must be installed according to their relative

installation instruction manuals and at a minimum

distance of 650 mm from the hob.

• Place the wall cabinets adjacent to the hood at a minimum

height of 420 mm from the hob (see figure).

600mm min.

• The installation cavity should have the dimensions

indicated in the figure.

Fastening hooks are provided, allowing you to fasten

the hob to tops that are between 20 and 40 mm thick.

To ensure the hob is securely fastened to the top, we

recommend you use all the hooks provided.

;

Hook fastening diagram

Hooking position

for top H=20mm

If the hob is installed beneath a wall

cabinet, the latter must be situated

at a minimum of 700 mm above

the hob.

555 mm

Hooking position

for top H=30mm