Indesit PAA 641 IX/I NL 사용 설명서 - 페이지 9

{카테고리_이름} Indesit PAA 641 IX/I NL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit PAA 641 IX/I NL 9 페이지.

페이지 인쇄

Respecting and conserving the environment

• Cook your food in closed pots or pans with well-fitting lids and use as little

water as possible. Cooking with the lid off will greatly increase energy

consumption.

• Use purely flat pots and pans.

• If you are cooking something that takes a long time, it's worth using a

pressure cooker, which is twice as fast and saves a third of the energy.

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the hob surface

• All the enamelled and glass parts should be cleaned with warm water and

neutral solution.

• Stainless steel surfaces may be stained by calcareous water or aggressive

detergents if left in contact for too long. Any food spills (water, sauce, coffee,

etc.) should be wiped away before they dry.

• Clean with warm water and neutral detergent, and then dry with a soft

cloth or chamois. Remove baked-on dirt with specific cleaners for stainless

steel surfaces.

• Clean stainless steel only with soft cloth or sponge.

• Do not use abrasive or corrosive products, chlorine-based cleaners or pan

scourers.

• Do not use steam cleaning appliances.

• Do not use flammable products.

• Do not leave acid or alkaline substances, such as vinegar, mustard, salt,

sugar or lemon juice on the hob.

Cleaning the hob parts

• Clean the enamelled and glass parts only with soft cloth or sponge.

• Grids, burner caps and burners can be removed to be cleaned.

• Clean them by hand with warm water and non-abrasive detergent,

removing any food residues and checking that none of the burner openings

is clogged.

• Rinse and dry.

• Refit burners and burner caps correctly in the respective housings.

• When replacing the grids, make sure that the panstand area is aligned

with the burner.

• Models equipped with electrical ignition plugs and safety device require

thorough cleaning of the plug end in order to ensure correct operation.

Check these items frequently, and if necessary, clean them with a damp

cloth. Any baked-on food should be removed with a toothpick or needle.

! To avoid damaging the electric ignition device, do not use it when the

burners are not in their housing.

Gas tap maintenance

Over time, the taps may become jammed or difficult to turn. If this happens,

the tap must be replaced.

! This procedure must be performed by a qualified technician authorised

by the manufacturer.

Troubleshooting

It may happen that the appliance does not function properly or at all. Before

calling the service centre for assistance, check if anything can be done. First,

check to see that there are no interruptions in the gas and electrical supplies,

and, in particular, that the gas valves for the mains are open.

The burner does not light or the flame is not even around the burner.

Check whether:

• The gas holes on the burner are clogged.

• All the movable parts that make up the burner are mounted correctly.

• There are draughts near the appliance.

The flame dies in models with a safety device.

Check to make sure that:

• You pressed the knob all the way in.

• You keep the knob pressed in long enough to activate the safety device.

• The gas holes are not blocked in the area corresponding to the safety

device.

The burner does not remain lit when set to minimum.

Check to make sure that:

• The gas holes are not blocked.

• There are no draughts near the appliance.

• The minimum setting has been adjusted properly.

The cookware is unstable.

Check to make sure that:

• The bottom of the cookware is perfectly flat.

• The cookware is positioned correctly at the centre of the burner.

• The pan support grids have been positioned correctly.

400011113624

05/2017 - XEROX FABRIANO