AEG 7000 Series 사용자 설명서 - 페이지 4
{카테고리_이름} AEG 7000 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 7000 Series 44 페이지.
AEG 7000 Series에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사용자 설명서 (49 페이지), 사용자 설명서 (32 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (36 페이지)
페이지 인쇄
4
www.aeg.com
The appliance shall be installed as a freestanding
•
product or below the kitchen worktop if space
margins permit.
Do not install the appliance behind a lockable door, a
•
sliding door or a door with a hinge on the opposite
side, that would prevent the appliance door from
being fully open.
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
The ventilation opening in the base must not be
•
covered by a carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied
•
through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on
and off by a utility.
Ensure good air ventilation in the room where the
•
appliance is installed to avoid the backflow of
unwanted gases into the room from appliances
burning gas or other fuels, including open fires.
Exhaust air must not be discharged into a flue which is
•
used for exhausting fumes from any appliances
burning gas or other fuels.
The operating water pressure at the water entry point
•
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
Do not exceed the maximum load of 8 kg (refer to the
•
"Programme chart" chapter).
The appliance must be connected to the water mains
•
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.