Indesit IDCA G35 S 사용 설명서 - 페이지 15

{카테고리_이름} Indesit IDCA G35 S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IDCA G35 S 48 페이지.
Indesit IDCA G35 S에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)

페이지 인쇄

Troubleshooting

If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical

(see Assistance).

Assistance Centre

Problem:

The dryer does not start.

The drying cycle does not start.

Drying times are too long.

The Empty water container

indicator light flashes, but the

dryer has been running for a short

time.

The Empty water container

indicator light is on but the water

container is not full.

The programme is finished but

the items are damper than

expected.

The Options and START/

PAUSE indicator lights flash and

one of the Maintenance or

Drying phases indicator lights

turns on without flashing.

The dryer is noisy during the first

few minutes of operation.

Possible causes / Solutions:

• The plug has not been inserted far enough into the socket to make contact.

• There has been a power cut.

• The fuse has burned out. Try connecting another appliance to the same socket.

• If an extension cord is used, try connecting the dryer plug directly into the socket.

• The door has not been closed properly.

• The programme has not been set correctly (see How to carry out a drying cycle).

START/PAUSE

• The

button has not been pressed (see How to carry out a drying cycle).

• A delayed start time has been set (see Programmes and options).

START/PAUSE

• The

button has been pressed; a short delay follows before the

dryer starts running. Wait for the drying cycle to start; do not press the

PAUSE

button otherwise the dryer switches to the pause mode and the drying

cycle will not start.

• The filter has not been cleaned (see Care and maintenance).

• The water container must be emptied? The "Empty water container" indicator light

flashes (see Care and maintenance).

• The condenser needs to be cleaned (see Care and maintenance).

• The heat setting is not suited to the type of fabric to be dried (see Programmes and

options).

• An incorrect drying time was selected for the type of load (see Laundry).

• The air intake grille or the rear air vents are clogged up (see Installation, and Care

and maintenance).

• The items are too wet (see Laundry).

• The dryer is overloaded (see Laundry).

• The water container was probably not emptied before starting the programme. Do

not wait for the signal for emptying the water container, but always check and

empty it before starting a new drying programme (see Description of the tumble

dryer).

• It is normal: the "Empty water container" indicator light flashes when the water

container is full. If the indicator light is on but is not flashing, it only signals that the

water container must be emptied (see Description of the tumble dryer).

For safety reasons, the dryer programmes last a maximum of 4 hours. If an

automatic programme has not detected the final dampness level required in this

interval, the dryer completes the programme and stops. Check the above points

and repeat the programme; if the items are still damp, contact the Technical

Assistance Centre (see Assistance).

• Switch the appliance off and unplug it, then clean the filter and condenser (see "Care

and Maintenance"). Reinsert the plug, switch the appliance on and start another

programme.

If the problem persists, contact the Technical Assistance Service.

• This is normal, especially if the dryer has not been used for a long time. If the noise

persists during the entire cycle, contact the Technical Assistance Centre.

START/