Indesit IDV 65 UK 지침 책자

{카테고리_이름} Indesit IDV 65 UK에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IDV 65 UK 4 페이지.

페이지 인쇄

Instruction booklet

TUMBLE DRYER

This symbol reminds you to read this booklet.

WHERE TO INSTALL THE TUMBLE DRYER

If you are going to install the

appliance under a work

counter be sure to leave a

10 mm space between the

top and any other objects on

or above the machine and a

15 mm

15 mm space between the

sides and any kitchen units

or walls to ensure proper air circulation. The

dryer must never be installed behind a lockable

door, a sliding door or a door with a hinge on the

opposite side to that of the dryer door.

The appliance must be installed with the rear

surface placed against a

VENTILATION

When the dryer is in use there has to be adequate

ventilation to avoid the back flow of gases into

the room from appliances burning other fuels,

including open fires.

The vent tube should not exceed 2.4

metres in length. The tube should be kept clear of the air intake

vent and kinks or 'U' bends must be avoided as these will obstruct

the tube and trap condensation.

VENTING

Air intake vent

Do not block or obstruct

Caution: Hot!

Wall mounting

Keep the tube as short and as straight

as possible to prevent condensation

forming in the vent pipe.

The duct in the wall should slope

slightly downwards.

Window mounting

The hole in the window should be as

low down as possible and the tube should be kept as short as

possible.Depending on how often you use your tumble dryer, it is

essential that areas

and

lint or debris.

IDV 75 UK

IDV 75 S UK

wall.

Vent Tube fitted here

are checked periodically to remove

other appliances that burn gas or other fuels.

Do not discharge exhaust air into an extraction system or any duct

with an extractor fan. This will affect the way the thermal controls

operate and can result in a fire hazard.

ELECTRICAL CONNECTIONS

The socket must be grounded. The power supply

cord should be checked periodically. If the

supply cord is damaged, it must be replaced by

the manufacturer, its service agent or similarly

qualified persons in order to avoid a hazar

LEVELLING YOUR DRYER

The dryer must be installed level for

correct operation. When you have

installed your dryer in its final location

check that it is first level side to side and

then back to front.

If the dryer is not level use a wooden

block to support it while adjusting the

two front legs up or down until your dryer is level.

BEFORE YOU START USING YOUR DRYER

Once you have installed your dryer and before you

use it clean the inside of the drum to remove any

dust that could have accumulated during transport

Step 1

Open the door of your dryer

Step 2

Pull out the filter (using the

two finger grips)

Step 3

Clean the fluff off the filter

and replace it correctly.

Ensure that the filter is

pushed fully home.

Step 4

Make sure the filter is pushed fully home

NEVER

run the dryer without the filter in position

Failure to clean the filter after EVERY drying

cycle will affect the drying performance of your

machine. It will take longer to dry and as a result

will use more electricity during drying.

At least every two or three months you MUST

clean fluff build up around the filter housing and

the vent tube.

Open window venting

The end of the tube should be

directed downwards, to prevent

warm moist air from condensing in

the room or dryer.

Do not discharge exhaust

air into a flue which is used

for exhaust fumes from