Indesit IDVA 735 사용 설명서 - 페이지 14

{카테고리_이름} Indesit IDVA 735에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IDVA 735 21 페이지. Tumble dryer
Indesit IDVA 735에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (20 페이지), 사용 설명서 (16 페이지), 사용 설명서 (20 페이지)

Indesit IDVA 735 사용 설명서
If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical
Assistance Centre
(see Assistance).
• The plug has not been inserted far enough into the socket to make contact.
• There has been a power cut.
• The the fuse has blown. Try connecting another appliance to the same socket.
• If an extension cord is used, try connecting the dryer plug directly into the socket.
• The door has not been closed properly.
• The programme has not been set correctly (see How to carry out a drying cycle).
• The
START/PAUSE
button has not been pressed (see How to carry out a drying cycle).
• A delayed start time has been set (see Programmes and options).
• The
START/PAUSE
button has been pressed; a short delay follows before the
dryer starts running. Wait for the drying cycle to start; do not press the
PAUSE
button otherwise the dryer switches to the pause mode and the drying
cycle will not start.
• The filter has not been cleaned (see Care and maintenance).
• The heat setting is not suited to the type of fabric to be dried (see Programmes and
options).
• An incorrect drying time was selected for the type of load (see Laundry).
• The flexible ventilation hose may be blocked (see Installation).
• The air inlet may be blocked or obstructed (see Installation).
• The fixed ventilation flap, on the protective weatherproof cover, may be obstructed
(see Installation).
• The items are too wet (see Laundry).
• The dryer is overloaded (see Laundry).
For safety reasons, the dryer programmes last a maximum of 4 hours. If an
automatic programme has not detected the final dampness level required in this
interval, the dryer completes the programme and stops. Check the above points
and repeat the programme; if the items are still damp, contact the Technical
Assistance Centre (see Assistance).
• Switch the appliance off and unplug it, then clean the filter (see "Care and
Maintenance"). Reinsert the plug, switch the appliance on and start another
programme.
If the problem persists, contact the Technical Assistance Service.
• This is normal, especially if the dryer has not been used for a long time. If the noise
persists during the entire cycle, contact the Technical Assistance Centre.
START/