Indesit IDVA 735 사용 설명서 - 페이지 3
{카테고리_이름} Indesit IDVA 735에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit IDVA 735 20 페이지. Tumble dryer
Indesit IDVA 735에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (21 페이지), 사용 설명서 (16 페이지), 사용 설명서 (20 페이지)
페이지 인쇄
Electrical connections
Before plugging the appliance into the socket, check the
following:
• Make sure your hands are dry.
• The socket must have an earth connection.
• The socket must be able to withstand the machine's ma-
ximum power output as indicated on the Rating plate (see
Description of the tumble dryer).
• The power supply voltage must fall within the values indicated
on the Rating plate (see Description of the tumble dryer).
• The socket must be compatible with the dryer's plug.
Should this not be the case, replace the plug or the socket.
!
Do not use extension cords.
!
The dryer must not be installed outdoors, even if the space
is sheltered. It can be very dangerous if exposed to rain or
storms.
!
Once installed, the dryer's electrical wire and plug must be
within reach.
!
The power cord must not be bent or squashed.
!
The power cord is supplied fitted with a BS1363 plug
and with a 13 amp BS1362 fuse. If it is necessary to fit a
replacement fuse, it must be a 13 Amp ASTA approved
to BS1362 type. WARNING: The plug must not be used
without a fuse cover. If a replacement fuse holder/cover is
required, it must be of the same colour coding or wording as
shown on the base of the plug.
Replacements are available from authorised dealers.
Moulded plug
Changing the plug
The wires in the power cord are coloured in accordance with
the following.
Green and Yellow (Earth)
wire to terminal marked "E",
symbol x, or coloured green
GREEN &
and yellow.
YELLOW
BROWN
Blue (Neutral) wire to
BLUE
terminal marked "N" or
coloured black.
!
If the plug being replaced is a non-rewirable type, then the
cut-off plug must be disposed of safely. DO NOT leave it where
it can be inserted into a socket and create a shock hazard.
!
The power cord should be checked periodically and replaced
by a cord specially prepared for this dryer and fitted only by
authorized technicians (see Service). New or longer power
cords are supplied at an extra charge by authorized dealers.
!
The manufacturer denies any responsibility should any of
these rules not be followed.
!
If in doubt about any of the above consult a qualified
electrician.
13A ASTA approved fuse
to BS 1362.
13 ampere fuse
Brown (live) wire to
teminal marked "L" or
CROSS-BAR
coloured red.
CORD GRIP
Levelling the tumble dryer
The tumble dryer should be installed level in order to
operate correctly.
After installing the tumble
dryer in its permanent
position, make sure it is level;
check its side-to-side levelling
first, followed by front-to-
back.
If the tumble dryer is not
perfectly level, use a wooden
block to support it while you
adjust the two front feet, up or
down as necessary.
Before you start your dryer
Once the tumble dryer is installed, clean the inside of the
drum before operating it and remove any dirt accumulated
during transportation.
EN
3