AEG A62710GNX1 사용자 설명서 - 페이지 11

{카테고리_이름} AEG A62710GNX1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG A62710GNX1 16 페이지.
AEG A62710GNX1에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Problem

Temperature cannot be set. The FROSTMATIC or

DEMO appears on the dis-

play.

The temperature in the ap-

pliance is too low/too high.

Side panels of the appli-

ance are warm.

Door does not open easily.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

8. TECHNICAL DATA

Height

Width

Depth

Possible cause

COOLMATIC function is

switched on.

The appliance is in demon-

stration mode.

The temperature regulator

is not set correctly.

The food products temper-

ature is too high.

The FROSTMATIC function

is switched on.

This is a normal state

caused by operation of the

heat exchanger.

You attempted to re-open

the door immediately after

closing.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

1850 mm

Rising time

595 mm

Voltage

668 mm

Frequency

ENGLISH

Solution

Switch off FROSTMATIC or

COOLMATIC manually, or wait

until the function resets auto-

matically to set the tempera-

ture. Refer to "FROSTMATIC

or COOLMATIC function".

Keep the OK pressed for ap-

proximately 10 seconds until a

long sound is heard and dis-

play shuts off for a short time.

Set a higher/lower tempera-

ture.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Refer to "FROSTMATIC func-

tion".

Make sure that there is at least

30 mm of space between each

side of the appliance and the

surrounding furniture when

the ambient temperature ex-

ceeds 38°C.

Wait a few seconds between

closing and re-opening of the

door.

15 h

230 - 240 V

50 Hz