AEG ABE812E6NC 사용자 설명서 - 페이지 16

{카테고리_이름} AEG ABE812E6NC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ABE812E6NC 40 페이지.
AEG ABE812E6NC에 대해서도 마찬가지입니다: 설치 지침 (12 페이지)

페이지 인쇄

www.aeg.com

Problem

Temperature cannot be set.

The temperature in the ap-

pliance is too low/too high.

DEMO appears on the dis-

play.

shown instead of numbers

on the temperature display.

If the advice does not lead

to the desired result, call the

nearest Authorized Service

Centre.

8.2 Closing the door

1. Clean the door gaskets.

Possible cause

The "Frostmatic function" is

switched on.

The temperature is not set

correctly.

The door is not closed cor-

rectly.

The food products' tempera-

ture is too high.

Many food products are stor-

ed at the same time.

The door has been opened

often.

The Frostmatic function is

switched on.

There is no cold air circula-

tion in the appliance.

The appliance is in demon-

stration mode.

Temperature sensor prob-

symbol is

lem.

Solution

Switch off "Frostmatic func-

tion" manually, or wait until

the function deactivates au-

tomatically to set the tem-

perature. Refer to "Frostmat-

ic function" section.

Set a higher/lower tempera-

ture.

Refer to "Closing the door"

section.

Let the food products tem-

perature decrease to room

temperature before storage.

Store less food products at

the same time.

Open the door only if neces-

sary.

Refer to "Frostmatic func-

tion" section.

Make sure that there is cold

air circulation in the appli-

ance. Refer to "Hints and

Tips" chapter.

Keep the OK key pressed for

approximately 10 seconds

until a long sound is heard

and the display turns off for

a short time.

Contact the nearest Author-

ized Service Centre (the

cooling system will continue

to keep food products cold,

but temperature adjustment

will not be possible).

2. If necessary, adjust the door. Refer to

installation instructions.

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.