AEG AGB62226NX 사용자 설명서 - 페이지 9
{카테고리_이름} AEG AGB62226NX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG AGB62226NX 12 페이지.
페이지 인쇄
Problem
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set. The FROSTMATIC or
The temperature in the ap-
pliance is too low/too high.
Door does not open easily.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
7. INSTALLATION
WARNING!
Refer to Safety chapters.
Possible cause
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FROSTMATIC function
is switched on.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
COOLMATIC function is
switched on.
The temperature regulator
is not set correctly.
The food products temper-
ature is too high.
The FROSTMATIC function
is switched on.
You attempted to re-open
the door immediately after
closing.
7.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
ENGLISH
Solution
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "FROSTMATIC func-
tion".
The compressor starts after
some time.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Refer to "FROSTMATIC func-
tion".
Wait a few seconds between
closing and re-opening of the
door.
9