A-Neuvideo HD-44G 사용 설명서 - 페이지 15
{카테고리_이름} A-Neuvideo HD-44G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neuvideo HD-44G 20 페이지. Ethernet (tcp) set up
A-Neuvideo HD-44G에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (6 페이지)
페이지 인쇄
A
NEUVIDEO
EDID function Setup
EDID setup
Step 1. Press the EDID button
Step 2. Press SOURCE #1 or #2 button row
Step 3. Press the ENTER button
Embedded EDID modes
Embedded EDID setup
EDID > SOURCE > ENTER
Press
SOURCE #1 or SOURCE #2
Select Embedded EDID :
Mode 1 : FSS
Mode 2 : H24-3D
Mode 3 : H24-3D-M
Mode 4 : H36-3D
Mode 5 : H36-3D-M
Mode 6 : DVI-D 1280x1024-60Hz
Mode 7 : DVI-D 1920x1200-60Hz
LEARNING EDID
Learning EDID setup
Press
EDID > DESTINATION > SOURCE >
ENTER
NOTE : The already learned EDID cannot be modified. You can only rebuild a new Learning EDID.
For example: When the Source has "Learned" the EDID data from a destination, It will save that EDID information into EPROM and the
EDID data cannot change. Please select new learning destination to sources or change to one of the embedded EDID modes when you
want to remove the learning EDID memory from EPROM.
To change the EDID setup
The display will show the currently selected EDID mode
The button will flash blue and the display will show the current Embedded EDID Status.
To set EDID mode.
The switcher will return to operation mode.
Operation will abort if no keys are pressed within 5 seconds.
Total 7 EDID Modes
To select Embedded EDID mode or LEARNING mode
Press EDID button : The LCM will show the current EDID status.
Repeatedly depressing the source 1 button will cycle up thru the options.
Repeatedly depressing the source 2 button will cycle down thru the options.
Learning EDID from Destination to Source
Press EDID > Switcher will LEARN destination EDID and pass the selected source.
Press: EDID > DESTINATION #1 > Switcher will LEARN destination #1 EDID and
pass the selected source.
13