A-Neuvideo HD-44G 사용 설명서 - 페이지 11

{카테고리_이름} A-Neuvideo HD-44G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neuvideo HD-44G 20 페이지. Ethernet (tcp) set up
A-Neuvideo HD-44G에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (6 페이지)

페이지 인쇄

Before making any connections to the switcher. Observe the following:

> Ensure the mains voltage supply matches the label on the

supplied plug-pack (+/- 10%)

> Ensure that the power switch is OFF

> Ensure that all system grounds (earth) are connected to a

common point.

> Avoid powering equipment within a system from multiple power

sources that may be separated by large distances

IR REMOTE CONTROL KEY

SWITCH POWER ON or OFF

Controller with a separate power ON and OFF

DESTINATION : 1 thru 4 OUTPUT SELECTION

Press the destination button to select the output display channel.

SOURCE : 1 thru 4 INPUT SOURCE SELECTION

Press input 1~ 4 sources with selection button

FUNCTION KEY

ALL - function selection button

DEMO or ENTER - function selection button

EDID - function selection button

LOCK - function selection button

SELECT EDID MODES : press source button 1 thru 2.

1. Mode 1 : FSS (Fast Speed Start)

2. Mode 2 : H24-3D

3. Mode 3 : H24M-3D

4. Mode 4 : H36

5. Mode 5 : H36M

6. Mode 6 : H36-3D

7. Mode 7 : H36M-3D

REMOTE CONTROL

> Connect all audio video sources and destination equipment

> Power up all source and destination audio-visual sources

> For each destination output select the appropriate input source

by using the front panel input 1~8 select buttons. The supplied

IR remote control. Or through the RS-232 serial communications

port.

> Upon power up the switcher will return to its last used setting

before powered down.