AEG ARCTIS U 86050 i 작동 및 설치 지침 - 페이지 21

{카테고리_이름} AEG ARCTIS U 86050 i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ARCTIS U 86050 i 32 페이지. Built-in freezer

Starting up and temperature regulation

1. Turn the thermostat control knob (1) in the direction of "1".

The green light (3) and the red light (4) come on, the audible warning

sounds (if fitted), and the refrigeration motor starts up.

2. Additionally operate the fast-freeze switch (6).

The yellow pilot light (5) comes on, the audible warning switches off,

and the freezer motor runs continuously.

3. Only when the red light (4) has gone out should you reset the fast-

freeze switch (6) the yellow light (5) goes out and the audible warning

is activated again.

The temperature regulator (1) can be used to set the required storage

temperature, -18°C or colder.

Setting "1" means:

highest, warmest internal temperature

Setting "4" means:

lowest, coldest internal temperature

Recommended regulator setting:

1.5 to 2.

Important: Regularly check on the red temperature pilot light (4) and

the thermometer that the required storage temperature is being main-

tained.

There are two ice packs in one drawer of the freezer.

Refer to the section "Prior to Initial Start–Up" concerning freezing of

the ice packs.

In the event of a power failure or malfunction, the ice packs will

lengthen the amount of time it takes for the frozen food to defrost by

several hours.

The ice packs can only fulfil this task if they are placed in the upper-

most drawer, at the front, above the frozen food.

You can use the ice packs for cooling cold bags.