AEG C 718 40 i 작동 및 설치 지침 - 페이지 19

{카테고리_이름} AEG C 718 40 i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG C 718 40 i 28 페이지. Integrating fridge freezer

Installation Location

This appliance should only be installed at a location where the ambient

temperature corresponds to the climate classification indicated on the rat-

ing plate, which is located on the inside left of the appliance.

The following table shows which ambient temperature is correct for each

climate classification.

Climate classification

The appliance should be located in a dry atmosphere, out of direct sunlight

and away from continuous heat and extreme temperature, e.g. not next to

a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-

peratures are exceeded i.e. warmer or colder, then the appliance may not

operate correctly.

For building-in and door reversal instructions please refer to the relevant

instructions on the following pages.

For safety reasons, minimum ventila-

tion must be as shown Fig.

Attention: keep ventilation openings

clear of obstruction;

The side the door opens can be changed from the right side (factory adjust-

ment) to the left side, if the installation site requires.

Warning! When changing the side the door opens, the appliance must not

be connected to the mains. Remove plug from the mains beforehand.

for an ambient temperature of

+10 to +32 °C

+16 to +32 °C

min.

50 mm

200 cm

D567

min.

200 cm